Sealey CST997.V2 Quick Start Manual

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. Safety
9
Always distribute the load evenly over the surface of the bed.
8
Do not overload the truck - see Specification.
8
Do not leave unattended, especially when loaded, unless the wheels are chocked or the truck is otherwise secured.
8
Do not use truck on uneven ground and Do not run over curbs or steps - use a ramp.
8
Do not allow others to ride on the truck.
8
Do not use the truck if any part is damaged, paying particular attention to the wheels.
8
Do not inflate the tyres more than 30p.s.i.
2. IntroDuctIon
Heavy-duty steel with hinged mesh construction. Cushioned grip pull handle with smooth steering action for easy manoeuvrability. Steel centred
pneumatic wheels allow transport over the toughest terrain. drop-down sides, for easy loading, are also removable, allowing use as a flatbed for
oversized items. Suitable for a variety of warehouse, office, garden and domestic hauling applications.
3. SPecIfIcatIon
model no. .............................................................. cSt997.V2
Max. load ........................................................................200kg
Tyre diameter ................................................................250mm
Tyre Thickness ................................................................90mm
depth of Cart .................................................................220mm
Cart Width .....................................................................480mm
Cart length ....................................................................930mm
overall Height ................................................................570mm
4. aSSembly
4.1. Check contents against the parts list, if anything is missing or
damaged contact your local Sealey Stockist.
4.2. Turn the truck bed upside down and lay it on a level floor with
something underneath it to prevent it being scratched.
4.3. Bolt the rear axle support (see fig.1-3) to the bed using two 8 x
20mm bolts, two washers and two 8mm nuts (see fig.1-20).
4.4. Slide one end of each rear axle brace (see fig.1-4&5) over the
axle and bolt each one to the bed as indicated in fig.1 using two
8 x 20mm bolts, two washers and two 8mm nuts for each brace.
Tighten all nuts securely.
4.5. Assemble the front support/steering assembly completely before
bolting it to the bed.
4.6. Attach the steering link connector to the axle guides (see fig.2-
9) using two 8 x 15 short shoulder bolts with matching nuts and
washers.
note: Attach the steering link connector on the bed side of the axle
guides.
4.7. Place the yoke (see fig.2-8) into position in the steering
assembly ensuring that the short arm of the yoke drops onto the
pivot pin in the centre of the front axle support (see fig.2-A).
Secure in position using a cotter pin through the hole in the end
of the pivot pin.
4.8. Bolt the long arm of the yoke to the steering link connector using
one 8 x 15 short shoulder bolt with matching 6mm nut and washer.
4.9. Attach the centre front axle brace (see fig.2-7) to the steering
assembly at point 'C'. Use the long shoulder bolt together with
matching 6mm nut and washer.
© Jack Sealey limited
Platform truck
cSt997.V2
Model no:
Original Language Version
fig.1
fig.2
CST997.V2 Issue 2 (HF) 15/10/18