How To Replace The Foot Pedal; How To Replace The Battery - Dynacraft 24V PRINCESS CARRIAGE Owner's Manual

HOW TO REPLACE THE FOOT PEDAL

1. Use a flat head screwdriver to gently pry the LEFT side of foot pedal.
2. Gently remove the foot pedal.
3. Disconnect the old foot pedal from the pedal switch socket.
4. Replace and reconnect the new foot pedal to the pedal switch socket to ensure
they are connected in the correct position (see Figure 3) and then reinsert the
foot pedal into the foot pedal compartment until it snaps into place.
1

HOW TO REPLACE THE BATTERY

1. Unscrew the screws on the battery box cover with a screwdriver and remove the
battery box cover by lifting up.
2. Use a screwdriver to remove the four screws and the battery cover.
3. Unplug the battery connector (which is connected to the battery).
4. Carefully lift the dead battery out and replace it with a new one.
5. Replace the battery cover and secure it with the screws. Plug the control module
connector into the battery connector and replace the battery box cover.
4x12 Round
Head Screw
Battery Box
Cover
25
2
Control Module
Connector
Battery
Cover
Battery
Connector
Battery
Pedal Switch Socket
3
4x12 Round
Head Screw
Battery
connector