Motorola 533AFDMTB Manual page 26

You should clean the appliance interiors regularly. It will be easier to clean
when food stocks are low. Wipe the inside of the fridge/ freezer with a weak
solution of bicarbonate of soda, and then rinse with warm water using a
wrung-out sponge or cloth. Wipe completely dry before replacing the shelves
and baskets.
Thoroughly dry all surfaces and removable parts.
Although this appliance automatically defrosts, a layer of frost may occur on
the freezer compartment's interior walls if the freezer door is opened
frequently or kept open for too long. If the frost is too thick, choose a time
when the supply of food stocks are low and proceed as follows:
1. Remove existing food and accessories baskets, unplug the appliance from
the mains power and leave the doors open. Ventilate the room thoroughly to
accelerate the thawing process.
2. When defrosting is completed, clean your freezer as described above.
Caution! Don't use sharp objects to remove frost from the freezer
compartment. Only after the interior is completely dry should the appliance be
switched back on and plugged back into the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky food and drinks can cause seals to
stick to the cabinet and tear when you open the door. Wash seal with a mild
detergent and warm water. Rinse and dry it thoroughly after cleaning.
Caution! Only after the door seals are completely dry should the appliance be
powered on.
Replacing the LED light:
Warning: The LED light must not be replaced by the user! If the LED light is
damaged, contact the brand helpdesk for assistance. To replace the LED light,
the below steps can be followed:
1. Unplug your appliance.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and pull it with the other hand while
pressing the connector latch.
4. Replace LED light and snap it correctly in place.