Turning Off; Adjusting The Pressure - Ozito ACP-24151 Instruction Manual

Preset Pressure
The minimum and maximum
preset tank pressure is set at
the factory and the operator
should not alter it.
Switch-On pressure: 6 bar
Switch-Off pressure: 8 bar
Note: When the maximum preset tank pressure is reached, the
motor will automatically switch Off. As the compressed air is used, the
pressure will drop until it reaches the preset minimum pressure, when
the minimum pressure is reached the compressor will turn on again
automatically to build up/maintain pressure.

Adjusting the Pressure

Once set up and operating you can adjust the air pressure by turning
the pressure regulating knob.
1 To increase the air
pressure, rotate the
regulating knob clockwise.
2 To decrease the pressure,
rotate the regulating knob
anti-clockwise, past the
desired pressure. Then
rotate the regulating knob
clockwise to meet the
desired pressure.
Note: Air must be flowing through the quick release air outlet, and the
attached air tool in order to obtain the correct output reading on the
pressure gauge.
8
10
6
6
100
4
4 150 12 8
100
50
50
200
2
150 10
2 14
0 psi 230
170
psi
0
0 bar
16 12
bar
8
6 10
6
100
4
150 12
4 8
100
50
50
200
2
150
2 14 10
0 psi 230
170
psi
0
0 bar
bar 16 12

Turning Off

After the job has been completed, the compressor should be switched
off and the pressure released following the steps below.
1 P ush the on/off switch
down into the off position
to switch the compressor
off.
2 S witch off the mains power
supply and remove the electrical
plug.
3 Release the remaining
compressed air in the tank by
use of an air tool (blow gun
etc).
8
6 10
6
100
4
4 150 12 8
100
50
50
200 2
2 14 150 10
0 psi 230
psi 170
0 bar
0
bar 16 12