Advertisement
2.2.6
SPECIAL INSTRUCTIONS
The wheel fastening is shown in the figure and must always be done by placing
the washer with the ball support in between towards the rim.
Before travelling each time it is advisable to check the tightness of the nuts and
the pressure of the tyres. In addition, make sure that the pins are locked with split
pins.
When the crane is parked it must be blocked with 4 wedges under the rear
wheels. The wedges must be suitable for a wheel of diameter approximately
84 cm.
2.2.7
TOWING OPERATIONS NOT PERMITTED
The following towing operations are definitely not permissible:
• towing with the wheels sunk in the ground
• towing the crane from points other than the drawbar
• towing with low tyre pressures
• towing the crane sideways
• towing by exerting a greater force than the permissible load on the drawbar
• towing with parts not securely fastened or potentially free to unhook
•
towing with persons on the crane
• accompanying the crane by walking in hazardous zones
• towing the crane when it is not completely folded back into the towing position
CBR 40H
rev.
2 SITE PREPARATION - TRANSPORT
40H_2i_08
page 2.08
Hide quick links:
Advertisement
Need help?
Do you have a question about the CBR 40H-4 and is the answer not in the manual?
Questions and answers