VELOCITY X RC BOAT User Manual IMPORTANT STATEMENT Thank you for buying a Force1 RC boat. Please read this manual carefully before operating the RC Boat. By reading this manual it is assumed you are accepting all content in this user manual when using this RC Boat.
FORCE1 RC IMPORTANT SAFETY NOTICE FOR RC BOAT BATTERY * Keep Li-Ion batteries away from children and animals. * Never use or charge a Li-Ion battery that has ballooned or swelled. * Never use or charge a Li-Ion battery that has been punctured or damaged.
VELOCITY X RC BOAT User Manual LI-ION BATTERY CARE INSTRUCTIONS Temperature: charging, problems could occur which may damage the cell. down before recharging. Storage: • When storing LiPo / Li-Ion batteries for any length of time, they should ideally be stored at a temperature of between 5ºC/40°F &...
FORCE1 RC CHARGING INSTRUCTIONS FOR BOAT BATTERY 1. Plug the white battery cable into the charging cable. 2. Choose one of the methods as pictured below to connect with USB plug. LI-ION BATTERY DISPOSAL & RECYCLING Lithium-Ion batteries must not be placed with household trash.
FORCE1 RC TRANSMITTER OVERVIEW LEFT TRIM RIGHT TRIM BACKWARDS TRIM FORWARD TRIM THROTTLE ROCKER DIRECTION ROCKER TURNING DEGREE / DEMO LCD OVERVIEW FORWARD/BACKWARD TRIM SIGNAL BATTERY CHARGE LEFT/RIGHT HAND MODE THROTTLE DIRECTION DISPLAY CH 1: FORWARD DISPLAY CH 2: BACKWARD DISPLAY...
VELOCITY X RC BOAT User Manual TRANSMITTER BATTERY INSTALLATION Unscrew and open the battery cover on the back side of the transmitter and put 4 alkaline batteries (AA, not included) into the box in accordance with electrode instructions, as shown below.
FORCE1 RC BOAT BATTERY INSTALLATION 1. Turn the cabin switch either right or left to unlock. Remove the Cabin Cover (Picture 3). 2. Turn the 4 switches to unlock the Inner Hatch. Remove the Inner Hatch (Picture 4). 3. Put the Boat Battery into the battery holder of the hull (Picture 5).
VELOCITY X RC BOAT User Manual MAINTENANCE 1. After operation, please remove the battery. 2. After operation, dry the outside of the boat with a clean cloth. 3. If storing for extended periods of time, remove the transmitter battery to avoid battery leakage.
FORCE1 RC SPINDLE TUBE WALL LUBRICATION 1. Unscrew the battery holder from the hull (Picture 16). 2. Unscrew the motor cover (Picture 17). 3. Unplug the motor (Picture 18) and unscrew the motor and the spindel cover (Picture 19). 4. Remove the rubber cooling hose from the hull (Picture 20).
VELOCITY X RC BOAT User Manual 9. Apply lubrication to the spindel tube from the tail end as well (Picture 26). Push and rotate the spindel in and out of the tube in order to evenly distribute lubrication throughout the tube.
FORCE1 RC MODE 1 OPERATION CONTROLS MOVE FORWARD OR BACKWARD Push the THROTTLE STICK up and the boat moves forward. Pull the THROTTLE STICK down and the boat moves backward. TURN LEFT OR RIGHT While pushing the THROTTLE STICK pulling the left DIRECTION STICK left will make the boat turn to the left.
VELOCITY X RC BOAT User Manual MODE 1 TRIM ADJUSTMENTS BACKWARD FORWARD TRIM FORWARD OR BACKWARD TRIM TRIM When the boat is veering to the front or back, use the TRIM BUTTONS to correct the direction. When the boat is moving forward...
FORCE1 RC MODE 2 OPERATION CONTROLS Switching to Mode 2 on your remote (Left/Right Hand Mode - Page 8) will reverse the controls. MOVE FORWARD OR BACKWARD Push the THROTTLE STICK up and the boat moves forward. Pull the THROTTLE STICK down and the boat moves backward.
VELOCITY X RC BOAT User Manual MODE 2 TRIM ADJUSTMENTS FORWARD BACKWARD TRIM FORWARD OR BACKWARD TRIM TRIM When the boat is veering to the front or back, use the TRIM BUTTONS to correct the direction. When the boat is moving forward...
FORCE1 RC SPARE PARTS Recieving Plate Motor Battery Steering Engine 0001 0002 0003 0004 USB Charger Discharge Pipe Steering Engine Bar Propeller 0005 0006 0007 0008 Nose Guard Screw Spindle Tube 0009 0010 0011 Stern Rudder Position Tube Body Hatches...
Page 20
FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide residential protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not Installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Need help?
Do you have a question about the VELOCITY X RC and is the answer not in the manual?
Questions and answers