Advertisement
Quick Links
Advertisement
Related Manuals for simplehuman ST1004
Summary of Contents for simplehuman ST1004
- Page 1 set up guide...
-
Page 2: Quick Start
quick start prime the pump insert batteries adjust the volume • place your hand under • use a screwdriver to To change the amount dispensed, the sensor remove battery cover press buttons on the bottom of the pump. • insert 4 AA batteries •... - Page 3 & care Find answers easily online: • Your sensor pump dispenses soap, hand sanitizer, or lotion. www.simplehuman.com/service Please keep it simple: avoid soaps with exfoliants or beads. • To clean, wipe pump with a damp cloth—do not submerge in water...
- Page 4 We make our step cans in for any many sizes and styles. Find the one to match your space space www.simplehuman.com semi-round step can plastic slim step can round step can see the entire collection at www.simplehuman.com rectangular recycler butterfly step can slim step can...
- Page 5 < tools for efficient living ® www. .com 120-0294-01...
Need help?
Do you have a question about the ST1004 and is the answer not in the manual?
Questions and answers
How to set up
To set up the simplehuman ST1004 sensor pump:
1. Insert Batteries:
- Use a screwdriver to remove the battery cover.
- Insert 4 AA alkaline batteries as shown.
2. Fill the Reservoir:
- Unscrew the top and fill the chamber with soap, hand sanitizer, or lotion.
- Do not use soap with exfoliants or beads.
3. Prime the Pump:
- Place your hand under the sensor.
- Hold down the + button until soap starts dispensing.
4. Adjust the Volume:
- Press the + or - buttons on the bottom to change the amount dispensed.
5. Turn On/Off:
- Press and hold the - button to turn off.
- Press the + button to turn on.
Troubleshooting:
- If soap isn’t flowing, lightly poke the valve opening with a pin or paperclip. Be careful not to puncture the rubber area.
- If the LED turns red during operation, the batteries are low and need replacement.
This answer is automatically generated
How to use
To use the simplehuman ST1004 sensor pump:
1. Insert Batteries:
- Use a screwdriver to remove the battery cover.
- Insert 4 AA alkaline batteries as shown in the guide.
2. Fill the Reservoir:
- Unscrew the top and fill the chamber with soap, hand sanitizer, or lotion.
- Avoid using soaps with exfoliants or beads.
3. Prime the Pump:
- Place your hand under the sensor.
- Hold down the `+` button until soap dispenses.
4. Adjust the Volume:
- Use the `+` or `-` buttons on the bottom of the pump to change the amount dispensed.
5. Turn On/Off:
- Press and hold the `-` button to turn off.
- Press the `+` button to turn back on.
6. Troubleshooting:
- If soap isn’t flowing, lightly poke the valve opening with a pin or paperclip (do not push too far).
- If the LED turns red during operation, the batteries are low and need replacing.
7. Cleaning:
- Wipe with a damp cloth.
- Do not submerge in water or use in the shower.
This answer is automatically generated