KATEK Steca Solarix PLI5000-48 Setup Manual

KATEK Steca Solarix PLI5000-48 Setup Manual

Advertisement

Quick Links

Using PylonTech Lithium Batttery Packs with the Steca Solarix
PLI5000-48 Inverter Charger
Last Update 03.07.2018
Recommended Steca Solarix PLI 5000-48 setup for the
US2000Bplus, US3000B or PhantomS Li-Ion battery
models
The following setup and settings have been selected through
cooperation between Katek Memmingen GmbH and Pylon
Technologies Co., Ltd. (PylonTech). They represent recommended
values for cyclical applications as are typical in many solar PV
applications with a depth of discharge (DOD) of approximately 80%.
This recommendation is applicable to the
PylonTech US2000B, US2000Bplus, US3000B and Phantom-S battery models. We recommend using at least 4 pcs.
of the US2000B /
US2000Bplus / Phantom-S or 3 pcs. of the US3000B battery packs in parallel to reliably sustain the 5 kW full power
Two PylonTech US2000Bplus batteries stacked
Technologies Co., Ltd.
the battery bank and Solarix PLI with a rating of at least 150 Adc (slow). Additionally, it is recommended to use a
surge protector (SPD) on the battery terminals that protects from voltages above 60 to 65 Vdc (example: Citel
DS230S-48DC or similar), as well as on the PV side (Citel DS240S-110DC or similar). If using more than 4 battery
packs (or 3 for the US3000B), make sure to use two battery cable pairs in parallel between the battery and the
Solarix PLIs, each with their own fuses.
Make sure to always follow the requirements and guidelines from the battery manufacturer and verify the
settings with the data sheet of your batteries before applying them. Please contact your retailer in case of
uncertainty. Read the Steca Solarix PLI and battery manuals before applying these settings. Follow your local
regulations.
KATEK Memmingen GmbH | Mammostraße 1 | 87700 Memmingen | Germany | T + 49 (0) 8331 8558 - 0 | F + 49 (0) 8331 8558 - 131 | info@steca.com | www.katek-group.com | www.steca.com
Bank für Tirol und Voralberg | BLZ 720 123 00 | Kto.-Nr. 642 583 600 | BIC BTVADE61XXX | IBAN DE65 7201 2300 0642 5836 00 | EUR
Bank für Tirol und Voralberg | BLZ 720 123 00 | Kto.-Nr. 642 583 601 | BIC BTVADE61XXX | IBAN DE38 7201 2300 0642 5836 01 | USD
Geschäftsführer: Klauspeter Bader, Dr. Johannes Fues | Sitz der Gesellschaft: Memmingen | Amtsgericht Memmingen HRB 8226 | USt.-Id. Nr. DE 129 094 841
PylonTech US2000B,
of one Solarix PLI, without risking an over-current situation on
the batteries. Install one fuse or circuit breaker in each the positive and negative cable between
© Pylon

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Steca Solarix PLI5000-48 and is the answer not in the manual?

Questions and answers

Summary of Contents for KATEK Steca Solarix PLI5000-48

  • Page 1 KATEK Memmingen GmbH | Mammostraße 1 | 87700 Memmingen | Germany | T + 49 (0) 8331 8558 - 0 | F + 49 (0) 8331 8558 - 131 | info@steca.com | www.katek-group.com | www.steca.com Bank für Tirol und Voralberg | BLZ 720 123 00 | Kto.-Nr. 642 583 600 | BIC BTVADE61XXX | IBAN DE65 7201 2300 0642 5836 00 | EUR Bank für Tirol und Voralberg | BLZ 720 123 00 | Kto.-Nr.
  • Page 2 Switch to AC input set-point (relevant when using “SBU” or “Solar first” modes in program 01): KATEK Memmingen GmbH | Mammostraße 1 | 87700 Memmingen | Germany | T + 49 (0) 8331 8558 - 0 | F + 49 (0) 8331 8558 - 131 | info@steca.com | www.katek-group.com | www.steca.com Bank für Tirol und Voralberg | BLZ 720 123 00 | Kto.-Nr.
  • Page 3 Solarix PLI 5000-48 power up again. KATEK Memmingen GmbH | Mammostraße 1 | 87700 Memmingen | Germany | T + 49 (0) 8331 8558 - 0 | F + 49 (0) 8331 8558 - 131 | info@steca.com | www.katek-group.com | www.steca.com Bank für Tirol und Voralberg | BLZ 720 123 00 | Kto.-Nr.

Table of Contents