NEC Express5800 Series Maintenance Manual page 134

Chapter 3 Appendix
（1）
Error messages
Error Message
8000 System variable is corrupted. BIOS settings are invalid.
8001 Real time clock error
8002 Check date and time settings An incorrect time setting in
8003 System battery is dead -
Replace and run SETUP
8005 Previous boot incomplete -
Default configuration used
8006 System configuration data
cleared by Jumper.
8007 SETUP Menu Password cleared by
Jumper.
8020 BIOS update error.
8021
Recovery jumper is set, but
recovery images is not found.
8800 DXE_NB_ERROR
8801 DXE_NO_CON_IN
8802 DXE_NO_CON_OUT
8803 PEI_DXE_CORE_NOT_FOUND
8804 PEI_DXEIPL_NOT_FOUND
8805 DXE_ARCH_PROTOCOL_NOT_AVAIL
ABLE
8806 PEI_RESET_NOT_AVAILABLE
8807 DXE_RESET_NOT_AVAILABLE
8808 DXE_FLASH_UPDATE_FAILED
8830 PEI_RECOVERY_NO_CAPSULE
8831 PEI_RECOVERY_PPI_NOT_FOUND
8832 PEI_RECOVERY_FAILED
9000 Unsupported CPU detected
9001
Unsupported CPU detected on
CPU #1
9002 Unsupported CPU detected on
CPU #2
134
Cause
Real-time clock error occurred.
real-time clock was detected.
The battery for storing system
settings are dead.
The previous POST processing did
not finish.
The setup utility settings were
cleared using the jumper.
The setup utility password was
cleared using the jumper.
BIOS update failed.
Recovery jumper is set, but failed
to recover BIOS.
An error occurred during chip set
initialization.
An error occurred during console
initialization.
A BIOS flash ROM is corrupt.
The system was not reset correctly.
The BIOS Flash ROM was not
written to correctly.
The BIOS Flash ROM was not
recovered correctly.
An unsupported CPU was
detected.
Express5800/B120e-h Maintenance Guide
1. POST Error Message
Solution
Start BIOS Setup Utility (SETUP), and then
execute Load Setup Defaults and specify
the necessary settings. If the same error
continues to occur, contact your sales
representative.
Start SETUP, and then specify the correct
date and time. If the same error continues
to occur, contact your sales representative.
Contact your sales representative to
request a battery replacement. (After the
replacement, start SETUP, and then
specify the correct settings.)
Start BIOS Setup Utility (SETUP), and then
execute Load Setup Defaults and specify
the necessary settings.
Start SETUP, and specify the necessary
settings correctly. If the same
continues to occur, contact your sales
representative. This POST error may occur
when the battery is replaced.
This error appears when BIOS is updated.
If the same error occurs repeatedly, take an
action according to error details described
in BIOS release note, or contact your sales
representative.
Contact your sales representative.
(1/7)
error