Sealey AK5063 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE, FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO
MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP THESE INSTRUCTIONS SAFE FOR
FUTURE USE.
1. SAFETY INSTRUCTIONS
WARNING! Ensure Health & Safety, local authority and general workshop practice requirements are
adhered to when using this equipment. Familiarise yourself with the application and limitations, as well as
the potential hazards of the kit.
 This kit is suitable for flaring copper, brass or thin walled aluminium pipe. DO NOT use for flaring steel pipe.
 Maintain the kit in good condition.
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will
invalidate the warranty.
Locate the flaring tools in a suitable work area, keep the area clean and tidy and ensure there is adequate
lighting.
WARNING! Always wear approved eye or face protection when using the flaring tools.
 Keep children and unauthorised persons away from the working area.
 DO NOT use the kit for any purpose other than for which it is designed.
 DO NOT use the kit if any parts are damaged or missing as this may cause failure and/or personal injury.
 DO NOT allow untrained persons to use the kit.
 DO NOT attempt to flare piping when you are tired, under the influence of alcohol, drugs or intoxicating
medication.
 When not in use clean kit components, replace in case and store in a safe, dry, childproof area.
Remember! The safe operation of a vehicle, or other equipment, may well depend on the quality of the flare
produced. Discard any flare which is mis-formed.
WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all
possible conditions and situations that may occur. It must be understood that common sense and
caution are factors which cannot be built into this product, but must be applied by the operator.
2. CONTENT
Check the content of the kit against the list below. If any item is missing or damaged, contact your supplier
immediately.
Part No. Description
AK5063.01 Flare Dies (5 piece) - 1/2", 3/8", 5/16", 1/4", 3/16"
AK5063.02 Pipe Clamp
AK5063.03 Flare Press - 45
O
PIPE FLARING KIT
Instructions for:
AK5063
Model:
AK5063 - 5 - 01/11/07