VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
Page 3
This appliance is intended for use up to an altitude of 2000 m • above sea level. This appliance is not intended to be used on ships, boats or • vessels. Do not install the appliance behind a decorative door in order •...
WARNING: Ensure that the appliance is switched off before • replacing the lamp to avoid the possibility of electric shock. If the mains power supply cable is damaged, it must be • replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.
• If the mains socket is loose, do not connect the • Open the appliance door carefully. The use of mains plug. ingredients with alcohol can cause a mixture of • Do not pull the mains cable to disconnect the alcohol and air.
• Make sure the cavity and the door are wiped dry temperature, vibration, humidity, or are intended after each use. Steam produced during the to signal information about the operational operation of the appliance condensates on status of the appliance. They are not intended to cavity walls and can cause corrosion.
LEVELLING OF THE APPLIANCE COVERING TERMINAL BOARD • The recommended cross-section area is six Use small feet on the bottom of appliance to set the square millimetres (6 mm²). appliance top surface level with other surfaces. • When you refit the mains terminal cover, make sure that the lower tabs are located inside the ELECTRICAL INSTALLATION bottom edge of the aperture, before you fix the...
PRODUCT DESCRIPTION GENERAL OVERVIEW Control panel and hob Air vents for the cooling fan Heating element Lamp Shelf support, removable Shelf positions HOB OVERVIEW Induction cooking zone Control Panel COOKER CONTROL PANEL Knobs for the hob Knob for the top oven functions Knob for the main oven functions Temperature indicator / symbol for the main oven...
BEFORE FIRST USE WARNING! Refer to Safety chapters. Preheat the two ovens before first use. Heat up one oven at a time. Set the functions listed below, if applicable. INITIAL CLEANING Remove all accessories and removable shelf 1. Set the function .
Sensor Function Comment field Timer indicators of cooking To show for which zone you set the time. zones Timer display To show the time in minutes. To select the cooking zone. To increase or decrease the time. Hob²Hood To activate and deactivate the manual mode of the function.
OPTIHEAT CONTROL (3 STEP RESIDUAL AUTOMATIC HEAT UP HEAT INDICATOR) If you activate this function you can get a necessary heat setting faster. The function sets the highest WARNING! There is a heat setting for some time and then decreases to risk of burns from residual heat.
When the time comes to an end, the If you change the heat setting, the sound operates and 00 flashes. The function stops and the display shows cooking zone deactivates. the new heat setting. LOCK To stop the sound: touch CountUp Timer You can lock the sensors on the hob while cooking zones operate.
HOB²HOOD 2. Touch until you hear a beep and keep it It is an advanced automatic function which pressed until you hear the second beep. connects the hob to a special hood. Both the hob 3. Touch for 3 seconds until comes and the hood have an infrared signal communicator.
• The function activates when the total electricity load in the appliance is exceeded. • The function reduces the power of the cooking zones to prevent a circuit overload. • The heat setting display of the reduced zones changes between two levels. HOB - HINTS AND TIPS MINIMUM COOKWARE DIAMETER WARNING! Refer to Safety chapters.
you increase the heat setting, it is not proportional The data in the table is for guidance to the increase of the consumption of power. It only. means that a cooking zone with the medium heat setting uses less than a half of its power. Time Heat setting Use to:...
• Remove shiny metallic discoloration: use a solution of water with vinegar and clean the glass surface with a cloth. OVEN - DAILY USE WARNING! Refer to Safety chapters. TOP OVEN FUNCTIONS Symbol Oven function Application Off position The oven is off. Oven Lamp To turn on the lamp without a cooking function.
Page 17
ACTIVATING AND DEACTIVATING THE TOP / MAIN OVEN It depends on the model if your appliance has knob symbols, indicators or lamps: • The indicator comes on when the oven heats up. • The lamp comes on when the oven operates.
2. Put the deep pan into the oven on the necessary shelf position. OVEN - HINTS AND TIPS BAKING WARNING! Refer to Safety chapters. For the first baking, use the lower temperature. You can extend the baking time by 10 – 15 minutes if you bake cakes on more than one shelf position.
THERMAFLOW® BAKING - MAIN OVEN Shelf positions are not critical but ensure that the oven accessories are evenly spaced when more than one is used. Food Temperature (°C) Time (min) Shelf position Biscuits 180 - 190 10 - 20 1 – 3 Bread 190 - 210 30 - 35...
Food Time (min) Shelf position Kidneys - Lamb / Pig 6 - 10 2 - 3 Sausages 20 - 30 Steaks: Rare 4 - 6 Steaks: Medium 6 - 8 Steaks: Well Done 12 - 15 • Use the first shelf position. The one on the DEFROST bottom.
NOTES ON CLEANING Clean the front of the oven with a soft cloth with warm water and a mild detergent. Use a cleaning solution to clean metal surfaces. Clean stains with a mild detergent. Cleaning Agents Clean the cavity after each use. Fat accumulation or other residue may cause fire. Do not store the food in the oven for longer than 20 minutes.
2. Pull up the trim. 3. Remove the glass panels. To replace the glass panels, do the same steps in reverse. Before you lower the trim, attach the A trim part to the door. Refer to the image. REPLACING THE LAMP WARNING! Risk of electric shock.
Page 26
WHAT TO DO IF... Problem Possible cause Remedy You cannot activate the appli- The appliance is not connected Check if the appliance is cor- ance. to an electrical supply or it is rectly connected to the electri- connected incorrectly. cal supply. You cannot activate the appli- The fuse is blown.
......... Product number (PNC) ......... Serial number (S.N.) ......... ENERGY EFFICIENCY PRODUCT INFORMATION FOR HOB ACCORDING TO EU 66/2014 Model identification ZCI66080WA ZCI66080BA ZCI66080XA Type of hob Hob inside Freestanding Cooker Number of cooking zones Heating technology Induction Diameter of circular cooking zones (Ø)
• Put the smaller cookware on the smaller cooking zones. PRODUCT INFORMATION FOR OVENS AND PRODUCT INFORMATION SHEET* Supplier's name Zanussi ZCI66080WA Model identification ZCI66080BA ZCI66080XA Top oven: 105.6 Energy Efficiency Index Main oven: 95.4 Top oven: A...
Residual heat Keep food warm When the cooking duration is longer than 30 min, Choose the lowest possible temperature setting to reduce the oven temperature to minimum 3 - 10 use residual heat and keep a meal warm. min before the end of cooking. The residual heat Moist Fan Baking inside the oven will continue to cook.