Table of Contents
Advertisement
LED LIGHTING SETUP - SELECTED MODELS ONLY
FIT THE LED LIGHTS LOOSELY TO ALLOW THE CLEVERSPA
Correct installation of your LED lights is extremely important. Failure to follow instructions carefully
may result in failure.
Ensure lights are not installed too tightly. They must be fitted loosely, with freedom to move between
the retention loops on the base of the hot tub. Allow for some excess LED strip across each gap, this
will reduce stress on the lighting. This allows the lighting strip to expand when filled with water.
Failure to do this can reduce the lifespan of your lighting - please see FIG 1 below.
FIRST LIGHTING LOOP
START/END LIGHTING
EQUALITY SPACED
N.B. Style of CleverSpa®
may differ from image shown
ENSURE LIGHTING IS NOT TIGHT BETWEEN
LOOPS AND LEDS FACE THE BASE
N.B. When changing the battery in the remote control, replace with
a suitable CR2025 3V battery inserted with the + Symbol facing up.
RF REMOTE
CONTROL
& CR2025
3V BATTERY
1
Mains Power
Converter
LAST LIGHTING LOOP
FIG 1
HOW TO CONNECT THE LED LIGHTING KIT
IMPORTANT! Note the placement of alignment notches
TO EXPAND WHEN FILLED.
®
INITIAL LIGHTING SETUP
1. Connect lighting system together as shown in FIG 1.
2. Remove plastic tape from the battery compartment
on the remote.
3. Turn lights on with the power button.
INSTRUCTIONS
A
POWER
On / Standby
B
CHANGE MODE
Forwards / Backwards
C
CHANGE SPEED OF LIGHTS
'+' Faster / '–' Slower
D
CHANGE COLOURS
Forwards / Backwards
E
PRE-SET COLOURS
Select from a range of
pre-set solid colours
F
BRIGHTNESS
Adjust Lighting
brightness (5 levels)
: Increase Brightness
+
–
: Decrease Brightness
G
DEMO MODE
Cycles through pre-set
colours & effects
LIGHTING DOES NOT CORRESPOND TO COLOUR SELECTED
1. Turn on the lights using the red power button.
2. Press the solid green button once.
3. Turn off the power at the mains for 5 seconds.
4. Turn back on and immediately press and hold
the solid green button.
5. Release the button when the colour changes to green.
6. Wait 5 seconds for the change to take effect.
2
RF Wireless
Receiver
12
B
A
MODE
+
C
SPEED
SPEED
G
DEMO
–
+
D
COLOR
MODE
BRIGHT
+
–
+
COLOR
BRIGHT
–
–
E
RF Wireless
3
LED
Light Strip
F
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 180CM CIRCULAR and is the answer not in the manual?
Questions and answers
Water heater not working
The CLEVERSPA 180CM CIRCULAR water heater may not be working due to the following reasons:
1. Blocked or Dirty Filter – A dirty or old filter can block water flow, preventing the heater from circulating hot water properly.
2. Low Temperature – In cold weather, the SL error code may appear, indicating the pipe and heater are too cold to function.
3. Filter Installed Incorrectly – The filter may be screwed on too tightly, affecting water flow.
4. System Blockage – The HL error code indicates a blockage in the system, possibly due to a clogged filter, blocked impeller, or limescale buildup.
5. Filter Usage Time Exceeded – The FC error code appears after the filter has run for about 168 hours and needs to be checked or replaced.
Solutions include cleaning or replacing the filter, ensuring it is properly installed, checking for blockages, and restarting the system by turning off the mains power and plugging it back in after 10 seconds.
This answer is automatically generated