PHOENIX MANUFACTURING D8801 Owner's Manual

OWNER'S GUIDE
USE AND CARE MANUAL
UL Classified Industrial /
Commercial Evaporative Air Cooler
INSTALLER: Please deliver this guide to owner.
Safety
Installation
Start-up
Congratulations: You have purchased a product of superior performance and design, which will give the best service when properly installed, operated and maintained.
This guide was designed to provide you and your installer with information needed to mount, operate, inspect, maintain, and troubleshoot your Industrial / Commercial
evaporative air cooler.
The first section, Installation and Start-Up, is especially for the installer. The second section, Regular Maintenance, contains operational and maintenance instructions for the
owner and/or maintenance operations personnel, while Troubleshooting includes information on commonly encountered problems.
Read all instructions carefully before installation.
%
Use only the blower motor and circulating pump(s)
%
combinations marked on the Model Nameplate indicating
suitability for use in this model. Any other motors or pumps
cannot be substituted.
Installation work and electrical wiring must be done by
%
qualified person(s) in accordance with all applicable
codes and standards, including fire rated construction.
When cutting or drilling into a wall or ceiling, do not
%
damage electrical wiring or other concealed utilities (water
or gas lines, sewer lines, etc.).
Cooler motor, pump, cabinet and junction box must be
%
grounded in accordance with all local and national codes.
A ground wire must be used between the power supply
and the cooler.
Be sure that the cooler is connected to proper line voltage
%
stamped on the pump and blower (fan) motor specification
plate. NOTE: Improper voltage will void the pump and/or
motor warranties and may cause serious personal injury
or property damage.
Do not operate this blower (fan) motor with any solid-state
%
speed control device.
CONTENTS
Installation and Start-up
Introduction 2
Mounting requirements 2
Location and placement 2
Duct systems 2
Exhaust openings 2
Electrical requirements 3
Operation
Maintenance
Trouble Shooting
WARNING -
SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING.
Motor installation 3
Pump junction box location 4
Motor pulley adjustment 4
Belt adjustment 4
Overflow standpipe installation 4
Water line connections 4
Pump installation 4
P
HOENIX
TO REDUCE THE RISK OF FIRE, ELECTRIC
! Always disconnect electrical power to unit before
working on or servicing cooler. More than one
disconnect switch will be required to de-energize the
equipment for servicing.
! Do not remove pad frames while cooler is running, this
may cause the blower (fan) motor to overload and
damage the motor windings.
NOTE:
Do not locate unit near exhaust or vent pipes as odors or
!
fumes may be drawn into cooler.
Use of anode devices, chemical additives or treatments in
!
this cooler will void the warranty.
Your warranty does not cover shipping damage. Report all
!
shipping damage at once to dealer or carrier making the
delivery.
For future reference, record the model, serial numbers
!
and installation date of your evaporative cooler here:
Model #
Serial #
Install Date:
These Industrial / Commercial Evaporative Air Coolers are covered by
the following City of Los Angeles (C.O.L.A.) Research Reports.
Electrical: RR930159 (3/4, 1 & 1-1/2 Hp single phase applications),
Mechanical: RR8075 (all applications)
Bleed off installation 4
General inspections 5
Pre - start - up 5
Start-up Checklist 5
Cabinet Inspection 4
Maintenance
Cleaning 5-6
M I
ANUFACTURING, NC.
Draining and touch-up
Lubrication
Changing cooler pads
Pump mounting diagram
Troubleshooting
1-999-2174 DATE: 1/04
6
6
6
7
8