Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Quatreau PureH2O Touch
- Page 1 INSTALLATION Touch GUIDE BOILING CHILLED SPARKLING HOT & COLD...
-
Page 2: Table Of Contents
———————————————————— PRE-INSTALLATION CHECK LIST TYPE AA AIR GAP INSTALLATION • UNPACKING YOUR EQUIPMENT • INSTALLING THE QUATREAU TOUCH TAP • INSTALLING THE QT553-B (boiler control module) • INSTALLING THE CS20 • IMPORTANT INFORMATION CO N T E N T S... -
Page 3: Pre-Installation Check List
———————————————————— ———————————--------————————— QUATREAU TOUCH: PRE-INSTALLATION CHECK LIST Please read the installation notes on the last page of this manual. ———————————————————— ———————————--------————————— 1. Correct sized hole drilled in worktop i.e. 40mm set back approx 50mm from back edge of sink 2. Mains Cold Water: 1/2” lever ball valve, locatied top front right side wall of cupboard, set back 150mm from door, 500mm up from base. -
Page 4: Type Aa Air Gap
———————————————————— QUATREAU TOUCH TYPE AA AIR GAP ———————————————————— The drain out device is an essential and mandatory component for Quatreau ® tap installations. • Shown here (top right) connected to the tap Venturi™ on the boiling pipe feeding SmartTap or boiling chilled sparkling pipe feeding the TouchTap. -
Page 5: Installation
QT553-B is not stretched. the system so that you don’t have to lift it upwards, out of the box. Carefully place 1. INSTALLING THE QUATREAU TOUCH™ one hand under the front lip of the system The Touch requires a 40mm hole cut into... - Page 6 ———————————————————— or a template device to prevent the drill QUATREAU TOUCH bit moving when you start the cut. CONNNECTING YOUR TAP ———————————————————— Once the hole is prepared, remove any...
-
Page 7: Installing The Qt553-B (Boiler Control Module)
3/8” pipe at the closest point to isolator ———————————————————— and run a length of 1/4” pipe to the pure QUATREAU TOUCH inlet on the right hand side of the QT553-B. INSTALLING THE QT553-B Also connect the 1/4” isolation valve just ————————————————————... -
Page 8: Installing The Cs20
You will enables ventilation and air movement use several litres of water to commission without which the system will not chill the Quatreau system so it is sensible to correctly. commission with mains water first then ————————————————————... -
Page 9: Important Information
BY AUTHORISED QUATREAU TECHNICIAN ONLY INSTALLATION DATE INSTALLATION NOTES Installation of the Quatreau Touch is best achieved using the following sequences: Site the equipment to check it all fits, chiller to the left of the boiler. Install the TouchTap (note the comms cable must reach the boiler control unit).
Need help?
Do you have a question about the PureH2O Touch and is the answer not in the manual?
Questions and answers