Table of Contents
Advertisement
Front wheels - Tighten
WARNING
Roll-over hazard!
Never operate the machine with a loose wheel rim or disc. Always tighten nuts and/or bolts to the
specified torque value and at the recommended intervals.
Failure to comply could result in death or serious injury.
Tighten the wheel bolts (1) to the specified torque any time you remove the wheel assembly from the tractor or
loosen the wheel bolts.
Check and tighten wheel bolts (1) to proper torque specifications after the following hours of use:
• First 50 hours
• Every 250 hours
Front wheel hardware tightening torque.
• 47 N·m (35 lb ft)
Rear wheel hardware tightening torque.
• 65 N·m (48 lb ft)
7 - MAINTENANCE
7-47
W0346B
1
NHIL17CT00199AA
2
NHIL17CT00198AA
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Workmaster 25S and is the answer not in the manual?
Questions and answers
I had just bought a workmaster 25S with the Backhoe When I put it in neutral with it running and get off the seat it dies so I can never get on the back hall or turn the seat around with it running
The New Holland Workmaster 25S shuts off when put in neutral and the operator gets off the seat because of a safety feature related to the PTO and forward/reverse pedals. If the PTO is not in the "Rear" position or the forward/reverse pedals are slightly engaged, the tractor will shut off when the operator leaves the seat. Additionally, the neutral switch or PTO selector lever switch may vibrate enough to lose contact, causing the shutdown.
This answer is automatically generated
Park brake lever is loose and doesn't hold brake in place. How to fix