Piranha GTI PLUS Operator's Manual page 26

Manual_Piranha_6.0_eng_fr_sp.qxp
HUMAN/MARKER INTERFACE (HMI)
Anti Mechanical Bounce – Used in Semi Automatic Mode only. This trigger filter prevents inadver-
tent firing due to marker recoil. The setting is automatically adjusted based on current trigger debounce
(AMB value (ms) = Trigger Debounce / 2).
Empty Breech Safety – By monitoring the eye sensors, if a trigger pull is buffered and no ball
becomes present within one second, the Empty Breech Safety will come on and the buffered trigger pull will
be discarded. The user must release the trigger to turn off the Empty Breech Safety and continue firing.
HUMAN/MARKER INTERFACE (HMI)
There are three interfaces to your GTI Rampage board: the Trigger, the Power button and the Mode button.
Interface
POWER BUTTON
MODE BUTTON
TRIGGER
PROGRAMMING MODE
iFAULT™ OVERRIDE
Tournament Lock Switch
When the Tournament Lock Switch is engaged, the mode button will be disabled and
the programming mode will not be accessible, preventing you from making any mark-
er adjustments or switching modes. The Tournament Lock Switch is located on the cir-
cuit board inside the trigger frame. (Indicated by a circle in the photo to the right).
To regain the MODE button functionality to change modes or to access programming mode, simply turn the
marker off and switch the Tournament Lock Switch Off (UP). The programming mode is now accessible and
the mode button may also change modes while the marker is on.
25
2/6/08 5:04 PM
POWER ON
PRESS/HOLD UNTIL RED FLICKER LED. RELEASE AND MARKER IS READY TO FIRE.
POWER OFF
PRESS/HOLD 2 SECONDS UNTIL RED/GREEN/BLUE FLICKER LED. RELEASE AND MARKER IS OFF.
EYE CONTROL
TAP TO TOGGLE EYE DISABLE/ENABLE. (EYES OFF = SLOW ORANGE FLASH LED)
NOTE: TOURNAMENT LOCK SWITCH MUST BE TURNED OFF BEFORE ACCESS TO MODE BUTTON IS ENABLED.
FIRING MODE OPERATION
IN FIRING MODE, TAP TO TOGGLE FIRING MODE. MUST HAVE EYES ON TO CHANGE MODE.
PROGRAMMING MODE OPERATION
IN PROGRAMMING MODE, SELECTS SETPOINT FOR VERIFICATION/MODIFICATION.
CONFIRMS SETPOINT VALUE ENTRY FROM TRIGGER.
FIRING MODE OPERATION
IN FIRING MODE THIS FIRES THE MARKER.
PROGRAMMING MODE OPERATION
IN PROGRAMMING MODE,CYCLES THROUGH MARKER CONTROL SETPOINTS.
ENTER SETPOINT VALUES VIA TRIGGER PULLS.
NOTE: TOURNAMENT LOCK SWITCH MUST BE TURNED OFF BEFORE ACCESS TO PROGRAMMING MODE IS
ENABLED.
ENTER PROGRAMMING MODE
PULL/HOLD TRIGGER, THEN PRESS POWER BUTTON UNTIL 10X WHITE LED FLASH. RELEASE POWER
BUTTON &TRIGGER.
EXIT PROGRAMMING MODE
PRESS/HOLD THE POWER BUTTON FOR 2 SECONDS UNTIL RED/GREEN/BLUE FLICKER LED. RELEASE AND
MARKER IS OFF.
IFAULT™ OVERRIDE. PREEMPTS FIRING MODE LED DISPLAY.
Page 26
Function