Generic Endpoint Handler; Main Endpoint Handler; Eot Handler - Philips PDIUSBD12 Firmware Programming Manual

Interconnectivity
Firmware Programming Guide for PDIUSBD12

5.3 Generic Endpoint Handler

The Generic Out Endpoint has been configured to receive data packet from the host, which interprets it as LED
Control data. When MCU receives the Generic_Out token from the host (identified through the Read Interrupt
Register), the D12 interrupt bit has to be cleared. The Select Endpoint will clear the Generic_Out buffer and
then the buffer sequence. Next, MCU will need to verify the data length and interpret the data.
For Generic_In Endpoint, this endpoint has been configured to send the information of the button activity as a
byte to the host.
Generic Out Handler
Clear Generic Out Interrupt Bit
Read and Clear Generic Out Buffer
Data Length = 0?
Save the Data and Set bEPPFlag Bit
Yes
End of Generic Out Handler

5.4 Main Endpoint Handler

Since the Main In/Out Endpoints are configured to the DMA mode and the interrupts are disabled for these
endpoints, no ISR services are normally required for these endpoints. However, for safer code implementation,
we have put in place clear interrupt routine here.
Main Out Handler
Clear Main Out Interrupt Bit
End of Main Out Handler

5.5 EOT Handler

For more information on EOT handler, please refer to the section "DMA Support".
No
Clear Main In Interrupt Bit
End of Main In Handler
Philips Semiconductors - Asia Product Innovation Centre
Visit http://www.flexiusb.com
Generic In Handler
Clear Generic In Interrupt Bit
End of Generic In Handler
Main In Handler
Page 13 of 22