Page 2
Photo 4 Photo 5 Photo 7 Photo 8 Photo 9 Brother DR-250 Technical Instructions Step 3 Step 3: Using a small flat blade screwdriv- er, release the two locking clips on the back of the cartridge. (See Photo 4) Step 4...
Page 3
Brother DR-250 Technical Instruction Photo 10 Photo 11 Photo 12 Photo 13 Photo 14 Step 8 Lift the top cover of the cartridge to separate the two sections. (See Photo 10) Step 9 Lift the transfer roller away from the drum.
Page 4
Visit: www.futuregraphicsllc.com Photo 15 Photo 16 Photo 17 Photo 18 Photo 19 Brother DR-250 Technical Instructions Step 13 Slide the drum axle out from the drum. (See Photo 15) Step 14 Lift out the drum from the cartridge. Remove the gray drive gear from the end of the drum.
Page 5
Brother DR-250 Technical Instruction Photo 20 Photo 21 Photo 22 Photo 23 Photo 24 Step 18 Remove the metal developer roller bear- ing from the gear side of the cartridge. (See Photo 20) Step 19 Move the developer roller contact bar to the side.
Page 6
E-mail: info@futuregraphicsllc.com Photo 25 Photo 26 Photo 27 Photo 28 Photo 29 Website: Brother DR-250 Technical Instructions Step 22 Carefully remove the developer roller. (See Photo 25) Clean the cartridge using dry compressed air or a vacuum. Step 23 Remove the bearing and spring from the end of the developer roller.
Page 7
Brother DR-250 Technical Instruction Photo 30 Photo 31 Photo 32 Photo 33 Photo 34 Step 27 Pull the drive gear end of the developer roller out of the cartridge again. Install the contact end gear onto the developer roller axle. Place the contact bar back onto the developer roller.
Page 8
Insert toner cartridge and test. Brother DR-250 Technical Instructions R R E E S S E E T T T T I I N N G G T T H H E E D D R R U U M M C C O O U U N N T T E E R R...
Page 9
However, the same problems that haunt the DR-200 also plague the DR-250. Future Graphics (FG) is a distributor of compatible replacement parts and products for imagining equipment. None of FG's products are genuine OEM replacement parts and no affiliation or sponsorship is to be implied between FG and any OEM.
Need help?
Do you have a question about the DR-250 and is the answer not in the manual?
Questions and answers