Ergonomic Handlebar Grips; Control Unit For Gear Shifting System; Heinrich / Hannah - Alfine Arthur / Antonia / Emil / Emilia - Pinion; Control Unit Of Bosch E-Bike System Oskar / Heinrich / Hannah - C2G Schindelhauer Oskar Original Operating Instructions

22.2

Ergonomic handlebar grips

Adjust the handlebar grips so that your palms rest comfortably on the
handlebar grips and are supported while riding.
1. Loosen the two screws 1 on the handlebar grips sufficiently to allow
EN
you to tilt the handlebar grips (fig. 20).
2. Turn the handlebar grips to the desired position.
3. Tighten the two screws 1 on the handlebar grips
"Overview of tightening torques" on page 177 .
20
1 1
22.3

Control unit for gear shifting system:

Heinrich / Hannah - Alfine
Arthur / Antonia / Emil / Emilia - Pinion
Set the control unit of the gear shifting system so that you can operate it
safely and comfortably while riding.
1. Loosen the screw 1 on the control unit sufficiently to allow you to
move and tilt the control unit (fig. 21).
2. Put the control unit in the desired position.
3. Tighten the screw 1 on the control unit ⇨ chap. 60 "Overview of
tightening torques" on page 177 .
136
21
1 1
⇨ chap. 60
22.4 Control unit of Bosch e-bike system
Oskar / Heinrich / Hannah
Set the control unit of the Bosch e-bike system so that you can operate it
safely and comfortably and read the displays while riding.
1. Loosen the screw 1 on the control unit sufficiently to allow you to
move and tilt the control unit (fig. 22).
2. Put the control unit in the desired position.
3. Tighten the screw 1 on the control unit ⇨ chap. 60 "Overview of
tightening torques" on page 177 .
22
1

Commissioning and operation

23

Information on the use of e-bike systems

The battery is supplied partially charged and must be fully
charged before first use to ensure full performance.
For more detailed information and instructions, please read
and follow the enclosed manufacturer's instructions before
operating your e-bike with the respective e-bike system.
This chapter only describes the basic functions and makes no
claim to completeness.
Your Schindelhauer e-bike is equipped with a lithium-ion battery.
Lithium-ion batteries show no memory effect. After the first complete
charge, recharging from any level is possible without needing to wait.
Be sure to disconnect the battery from the charger once charging is
complete. This prevents constant recharging, which could have a negative
effect on the life of the battery.
The battery should be at room temperature before recharging
and before cycling to increase battery life and range.
1
24 Bosch e-bike system
Oskar / Heinrich / Hannah
24.1

Switching the Bosch e-bike system on and off

Insert the battery first if you have removed it beforehand ⇨ chap. 24.5
"Charging, removing and inserting the battery" on page 139.
Activation
• Press the On/Off button 1 on the display (fig. 23). The display now
shows you the current speed, assistance mode and battery charge
status.
Deactivation
• Press the On/Off button 1 on the display (fig. 23). After being switched
off, the e-bike system will shut down.
23
2
1
+
+
-
-
1
2
3 3
Automatic deactivation
If the e-bike is not moved and no button is pressed, the e-bike system
switches off automatically after about 10 minutes.
EN
137