Features; Operationg Instructions - DSR PROBOOSTER DSR108 Owner's Manual

EN

3. FEATURES

4. OPERATING INSTRUCTIONS
Pre-Charging
The DSR ProBooster must be pre-charged before it can be used to jump start your vehicle. The "Standard Mode" instructions
will guide you on using your current vehicle's "weak" battery to pre-charge the ProBooster. If your vehicle's battery is
completely discharged, or does not allow you to pre-charge the ProBooster, see "Alternative Pre-Charge Methods".
Standard Mode
In most cases, the weak battery can fully recharge the ProBooster.
Follow these steps to pre-charge your ProBooster and get your car started:
1. For a negative-ground vehicle (as in most vehicles), connect the POSITIVE (RED) clamp to the POSITIVE (POS, P, +) battery
post. Next, connect the NEGATIVE (BLACK) clamp to the vehicle chassis or engine block, away from the battery.
2. For a positive-ground vehicle, connect the NEGATIVE (BLACK) clamp to the NEGATIVE (NEG, N, -) battery post. Next,
connect the POSITIVE (RED) clamp to the vehicle chassis or engine block away from the battery.
3. The ProBooster will turn on automatically. Indicators will show the voltage of the vehicle's battery.
4. Press the ON/OFF button. The ProBooster will start to recharge itself. LED indicators show the ProBooster's voltage
during charging.
5. After the 14V indicator stops blinking, turn on the engine.
Alternative Pre-charge Methods
If your vehicle's battery is completely discharged, or is unable to charge the ProBooster, the Fault indicator will turn on
during charging. You can use one of the following alternative pre-charging methods:
1. From a USB
The ProBooster can be recharged from any 5V 2A USB port, using a Micro USB adapter (not included). Recharging starts
automatically.
2. From a 12V socket
The ProBooster can be recharged from a donor car's 12Vsocket. Plug in the 12V adapter. Charging starts automatically.
MO-DSR108&109-FR-NL-DE-EN-ES – CAA-20160811
1. Voltage indicator LEDs
2. Condition (Override/fault)
LED indicator
3. GLOW mode button
4. On/Off button
5. 12V DC charging cable
6. Wrench
7. Jumper clamps
8. 12V 10A Input port
9. 5V/2A Micro USB Input port
26 / 38