Related Manuals for SpaNet SV4
Summary of Contents for SpaNet SV4
- Page 2 Water Priming Mode Every time the power is turned on the SV controller will initiate a water priming Purge air from plumbing system sequence on start up. During a priming sequence the filtration pump will run for up to 20 seconds at a time in an attempt to purge air from the plumbing.
-
Page 3: Thermal Trip
Error Codes & Troubleshooting Problems ER-3 WATER PRIME How to troubleshoot spa problems Problem: Water prime failed – air detected in heater tube SV spa controllers feature self diagnostics and scrolling error messages to quickly Cause: Airlock in pipe work, low water level, dirty filter cartridges troubleshoot possible problems. - Page 4 Error Codes & Troubleshooting Problems How to troubleshoot spa problems ER-5 POOL TOO HOT ER-8 CTRL FAULT HVS Pool over temperature. Temperature sensor reading ≥ 45 Problem: Problem: Heater relay is on when it should be off Cause: High ambient temperatures (especially in summer months) have Cause: Power surge, periods of low or high voltage, water on spa pack caused water temperature to rise above set temp point, Excessive...
- Page 5 Heat Pump Error Codes Maintenance Timers Understanding heat pump error codes HEAT PUMP ERROR CODES SERVICE REMINDER MESSAGES If an optional heat pump is fitted and a heat pump fault condition is detected a warning Certain spa manufacturers will choose to take advantage of the inbuilt service message is scrolled across the touch pad LCD every 60 seconds and the heat pump is timer reminders available within the SV controller software.
- Page 6 Spa Net Pty Ltd Unit 4 103 Railway Road North Mulgrave NSW 2756 Australia Phone: +61 2 4587 7766 Fax: +61 2 4587 8766 www.spanet.com.au Technical Support & Service service@spanet.com.au Accounts Department accounts@spanet.com.au Sales Department sales@spanet.com.au SV Series Spa Controls...
Need help?
Do you have a question about the SV4 and is the answer not in the manual?
Questions and answers