Table of Contents
Advertisement
Specifications
Note: Specifications and design are subject to change
without notice.
AIR CONDITIONER
Cooling performance
Refrigerant
Recommended quantity of refrigerant
Evaporator—volumetric air flow of the blower
ELECTRICAL
Operating voltage
Fuse for radial blower / compressor
Fuse for axial blower
COMPRESSOR
Designation
Direction of rotation (viewing the pulley)
Operating speed
Piston displacement
Pressure-side connection
Suction-side connection
Magnetic clutch operating voltage
Magnetic clutch power consumption
Refrigerant oil
Refrigerant oil volume in compressor
Refrigerant oil—additional required to fill
air-conditioner system
Power consumption of air-conditioner system
Attachments/Accessories
A selection of Toro approved attachments and accessories are
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro genuine
parts. When it comes to reliability, Toro delivers replacement
parts designed to the exact engineering specification of our
equipment. For peace of mind, insist on Toro genuine parts.
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
4.2 kW
Using the Air Conditioner for
R134A
the First Time
850 g (1.87
lb)
1. Start the engine.
660 m
3
/h
2. Switch on the blower switch
(23,307
ft
3
/h)
3. Switch on the air-conditioning switch
4. Set the temperature controller
maximum Cold setting (full counterclockwise
12 V
direction).
15 A
Note: After 3 minutes, the air-outlet louvers should
25 A
emit cold air.
5. Adjust the fan speed and temperature control to
TM-08 HS
achieve the required amount of cooling.
clockwise
700 to 6000
Operating the Air-Conditioning
rpm
System
82
cm
3
/rev (5
inch
3
/rev)
Do not run the air-conditioning system without running
the engine as it will not function and the battery will be
3/4 inch
O-ring
discharged.
7/8 inch
To prevent premature failure of the compressor-shaft seals,
O-ring
run the air-conditioning system for 15 minutes every 14 days.
12 V
1. Set the switch to the O
0.45 W
2. Set the fan-speed switch to the desired speed.
ZXL 100
PAG
3. Set the temperature regulator to the required setting.
150 cm
3
Note: The thermostat in the system switches the
(9.15 inch
3
)
compressor on and off to maintain the set temperature.
25 cm
3
(1.53 inch
3
)
Operating the Heating System
2.5 kW
1. Set the switch to the O
2. Set the fan-speed switch to the desired speed.
3. Set the temperature regulator to the required setting.
6
(Figure
5).
(Figure
5).
(Figure
5) to the
position.
N
position.
FF
Advertisement
Table of Contents
