Getting Started - VTech Bounce & Discover Llama Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the back
of the handle. Use a screwdriver to loosen
the screw and then open the battery cover.
3. Remove old batteries by pulling up on the
side of each battery.
4. Install 2 new AAA batteries following the
diagram inside the battery box. (The use
of new alkaline batteries is recommended
for maximum performance.)
5. Replace the battery cover and tighten the
screw to secure.
W A RN I NG :
Adult assembly required for battery installation.
Keep batteries out of reach of children.
A TTE N TI O N :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
4