Advertisement
NMEA 2000 GATEWAY ASSEMBLY
Notice
After completing installation, these instructions should be placed with the product for the owner's future use.
This document is written to aid our dealers and company service personnel in the proper installation or service of
our products. Persons who are not familiar with these or similar products produced by Mercury Marine, and who
have not been trained in the recommended servicing or installation procedures should have the work performed
by an authorized Mercury Marine dealer technician. Improper installation or servicing of the Mercury product could
result in damage to the product or personal injury to the installer or persons operating the product.
Gateway Assemblies
a
b
c
Components in Kit
b
Features
The CAN light and NMEA light will turn on when data is being transmitted through the Gateway.
90-8M0065210 MARCH 2012
NOTICE
NOTICE
a
c
© 2012 Mercury Marine
a -
Single engine Gateway
b -
Helm Gateway (Axius and Zeus
installations)
c -
Multi Engine Gateway
49890
a -
Gateway module
b -
Cable ties (2)
c -
10‑16 x 0.88 in. mounting screws (4)
d -
NMEA "T" connector
d
50047
Page 1 / 5
Advertisement
Table of Contents
Related Manuals for Mercury NMEA 2000
Summary of Contents for Mercury NMEA 2000
- Page 1 This document is written to aid our dealers and company service personnel in the proper installation or service of our products. Persons who are not familiar with these or similar products produced by Mercury Marine, and who have not been trained in the recommended servicing or installation procedures should have the work performed by an authorized Mercury Marine dealer technician.
- Page 2 NMEA 2000 GATEWAY ASSEMBLY NOTE: The Gateway will not provide the operating power for devices on the NMEA 2000 network. The NMEA 2000 network will require its own power source. The NMEA power input should be switched and have appropriate circuit protection.
- Page 3 NMEA 2000 GATEWAY ASSEMBLY Connect the NMEA 2000 harness connector to the existing NMEA 2000 network. SmartCraft junction box Gateway module Existing NMEA 2000 network Chart plotter, GPS, radar, etc. Termination resistor NMEA 2000 power input harness (obtain from local source)
- Page 4 Gateway module is not connected to the NMEA bus. Check the connections on the NMEA bus accordingly. Power is not present at the NMEA 2000 harness connector. Gateway module is not connected to the NMEA and CAN bus. Check the connections on both sides accordingly.
- Page 5 W6250 Pioneer Road OptiMax, Precision Pilot, Pro Max, SeaCore, Skyhook, SmartCraft, Sport-Jet, Total Command, Verado, VesselView, Zero Effort, Zeus, #1 On The Water, M with Waves logo, Mercury with Waves logo, and SmartCraft Fond du Lac, WI 54936-1939 logo are all registered trademarks of Brunswick Corporation. Mercury Product Protection logo is a registered service mark of Brunswick Corporation.
Need help?
Do you have a question about the NMEA 2000 and is the answer not in the manual?
Questions and answers