Page 1
Q u i c k S t a r t G u i d e Do not attempt to install this equipment until you have fully read and understood the manual which can be found on our website https://www.espuk.com/technical_support/product_manuals/?cat=4 A knowledge of BS5839: Pt 1: 2017: Fire Detection and Alarm Systems for Buildings is essential. It is strongly recommended that a suitably qualified and competent person is consulted in connec on with the Fire Alarm System design and that the en system is commissioned in accordance with the...
Page 2
PCB. The panel is fi ed with an on board USB-B connector. This is to provide communica on via a suitable USB lead to a PC for programming of panel op ons using the MAGDUO configuration software. 26-1706-01...
Page 3
• MAX ZONE LENGTH 500M • UP TO 32 DEVICES PER ZONE • BUILT-IN EOL CAPABILITY IN ALL DEVICES • DETECTORS, SOUNDERS AND MANUAL CALL POINTS TO BE INSTALLED ON THE SAME PAIR OF WIRES • DO NOT USE A RESISTOR FOR EOL NETWORK CONNECTIONS ONLY AVAILABLE ON 4/8 ZONE PANEL TO ADD REPEATER MAXIMUM OF 8 REPEATER PANELS N/O CONTACT...
Page 4
ESP’s policy is one of continual improvement and the right to change a specification at any time without notice is reserved. Whilst every care has been taken to ensure that the contents of this document are correct at time of publication, ESP shall be under no liability whatsoever in respect of such contents.
Need help?
Do you have a question about the MAGDUO and is the answer not in the manual?
Questions and answers