Configuring Direct Movacomm Shortcuts - Siemens UTMC OTU Handbook

B.5 Configuring Direct MOVAComm shortcuts
Use this sequence to configure desktop shortcuts for MOVAComm direct IP
communication. MOVA Comm must be installed on the PC first and is available from
the TRL web site at http://www.trl.co.uk. Pre-generated shortcuts can also be copied
from the GeminiConnect download directory.
1. Make a copy of the MOVAComm shortcut on the desktop.
2. Rename it to "Local MOVA M6.0 Stream1" or similar.
3. Right-click and select "Properties"
4. Add the Target parameters /pcmova TCP 169.254.33.31:12001 and click OK.
See example below.
:
On firmware versions 3.0 and above, the base port number used by MOVA
can be configured on the ConfigStatus outstation web page. If the base port has
been changed, the port numbers (12001 etc) will need to be updated
accordingly.
5. Repeat the above steps for each MOVA stream, naming the shortcut accordingly
and changing the port number in the Target parameters according to the stream
number:-
/pcmova TCP 169.254.33.31:12002 - MOVA stream 2
/pcmova TCP 169.254.33.31:12003 - MOVA stream 3
/pcmova TCP 169.254.33.31:12004 - MOVA stream 4
667/HB/31601/000 Page 119
UTMC OTU/MOVA Handbook
Issue 5