Sealey MPS8.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
Refer to
instruction
manual
1. SAFETY
DO NOT sit on the motorcycle on the stand.
8
DO NOT start the motorcycle on the stand.
8
DO NOT mount the stand on tarmacadam, as the surface may be unstable.
8
DO NOT use the stand for a purpose it is not designed to perform.
8
DO NOT operate the stand if it is damaged.
8
DO NOT use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT allow untrained persons to operate the stand.
8
DO NOT make any modifications to the stand.
8
DO NOT operate the stand if parts are missing or damaged.
8
DO NOT exceed the maximum capacity.
8
maintain the stand in a good clean condition for the best and safest performance.
9
Locate the stand and motorcycle in a suitable area. Keep area clean, tidy and free from unrelated materials and ensure that there is
9
adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight of the stand
and the motorcycle.
maintain correct balance and footing whilst positioning the motorcycle on the stand, do not over reach.
9
Ensure that the floor is not slippery, wear non-slip footwear, also essential for safe operation of the foot pedal.
9
Keep children and unauthorised persons away from the work area.
9
Before removing a motorcycle from the stand, ensure that there are no obstructions or persons around the motorcycle.
9
Always support motorcycle to prevent falling.
9
If using as a front stand, always use in conjunction with another suitable rear stand to ensure full stability.
9
When not in use, store in a safe, dry, childproof location.
9
2. INTRODUCTION
I
Powder coated pressed steel frame, to ensure strength and durability. Ideal for use with off-road/trials bikes to easily lift the bike when
needing to perform maintenance/services or cleaning. Simple, one foot, step and lift mechanism means the bike can be instantly
raised in one motion. For added safety, features an 'over centre' locking toggle linkage to mechanically lock the lift at full height to
prevent accidental lowering, also fitted with hydraulic dampener for controlled descent.
3. SPECIFICATION
model no ................................................................. mPS8.V2
maximum capacity ....................................................... 150kg
minimum height .......................................................... 300mm
maximum height ......................................................... 410mm
© Jack Sealey Limited
qUICK LIFT OFF-ROAD/TRIALS BIKE STAND
MPS8.V2
mODEL NO:
Original Language Version
mPS8.V2 | Issue:2 (H,3,5,F) 27/06/19