Page 1
Bluetooth Transceiver Owner’s Guide M B 2 0 B L U E T O O T H T R A N S C E I V E R McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 www.mcintoshlabs.com...
FCC requirements. Modification not expressly This radio transmitter (IC: 2483A-MB20) has been approved by approved by McIntosh may void your authority, granted by the FCC, Industry Canada to operate with the antenna types listed below with to use the product.
5. Do not use this apparatus near water. NOTE: This equipment has been tested and found to comply MB20 Front View ....6 6. Clean only with a dry cloth. with the limits for a Class B digital device, pursuant 7.
Thank you Make a Note From all of us at McIntosh, thank you for purchasing our For future reference, you can jot down your serial MB20. The MB20 Bluetooth Transceiver is a precision number and purchase information here. We can identify instrument that will provide many years of enjoyment.
DACs. A059664 MB20 REAR 11/2/2020 Set the MB20 to the desired mode, either RX or TX, by Bluetooth Transmit and Receive support aptX HD for pushing the RX/TX Button located on the rear of the improved sound quality.
Power the MB20 button is in the released position, the MB20 is in Transmitter Mode. Pushing the RX/TX button Use the supplied AC/DC adapter with the will toggle between these two modes. included USB cable to power the MB20. You...
RX / T X OPTICAL Preference Button Digital Optical Digital Optical Right Left Right Left Input Ouput Analog Unbalanced Analog Unbalanced (RCA) Outputs (RCA) Inputs RX/TX DC 5 Volt Power Micro Button A059664 MB20 REAR 11/2/2020 USB Input Figure 3– MB20 Rear View...
Bluetooth Devices to choose from on the device you are device. trying to connect to the MB20, it is helpful to not have any other discoverable devices competing with the MB20 The Front Panel Button will glow Green in Transmitter when trying to pair.
Receiver Mode device via Bluetooth. When powered on, the MB20 will attempt to pair with In the Receiver Mode (RX), the MB20 will send a the last paired device for one minute. If that device is received Bluetooth signal to ALL these outputs: unavailable, the MB20 will enter Discovery Mode.
For this reason, you may wish to save the original You can use the Bluetooth menu of your connected box and packing material for your MB20. If you need device to connect and disconnect the MB20. any of the packing material, you can contact McIntosh Customer Service.
A2DP, SBC, AAC, aptX, aptX Low Latency, aptX HD logos are registered trademarks owned by Bluetooth SIG, Inc. and Digital Input any use of such marks by McIntosh up to 192kHz 24-bit Group, Inc. is under license. Other trademarks and trade names are Digital Ouput those of their respective owners.
Page 12
The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated who reserve the right to improve design without notice. Printed in the U.S.A. McIntosh Part Number 24109000 revF...
Need help?
Do you have a question about the MB20 and is the answer not in the manual?
Questions and answers