Troubleshooting; Control Panel Error Codes - CLEVERSPA BLACK LABEL Instruction Manual

SOME TIPS TO HELP YOU TO DIAGNOSE AND RECTIFY COMMON SOURCES OF TROUBLE:
PROBLEMS
Air jet system
is not operating
Heating system
does not operate
Filtering system
does not operate /
Rattling noise when
switching filter on
leakage
CleverSpa
®
Water not clean
Display temperature
is higher than 40 C,
o
after stopping heating
function / HL Code
Displayed & Beeping

CONTROL PANEL ERROR CODES

CODE CAUSE
FC When filtration system has worked for approx.
168 hours, FC will appear on display with a warning
tone. Red light will still be lit on filter, pump will not
be operational. Heating system will not work, and
red light will be out on heater.
HL Over Temperature / Temperature issue
SL
Temperature Issue
SH
Water Temperature sensor issue
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household waste throughout the EU. To prevent possible harm to the
environment, or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take
this product for environmental safe recycling.

TROUBLESHOOTING

POTENTIAL CAUSES
A1 Air pump too hot
A2 Air Pump in cooling mode
A3 Possible fault with the
hot tub motor
A1 Temperature is set too low
A2 Dirty filter cartridge
A3 Improper water levels
A4 Heating element failure
A1 Dirty filter cartridge
A2 Filter screwed on too tight
A3 Possible fault with the
hot tub motor.
A1 CleverSpa
is torn or punctured
®
A1 Insufficient filtering time
A2 Dirty filter cartridge
A3 Improper water maintenance
A1 Residual water in the CleverSpa
will continue to be heated
by residual temperature
A2 Water inlet through filter system
may be blocked
SOLUTIONS
A1 Unplug system. After air pump has
cooled, insert plug and press air jets
button to activate
A2 Wait for 10 Minutes and restart
A3 Call CleverSpa
A1 Set to a higher temperature (20-40°C)
than current water temperature
A2 Clean/replace filter cartridge
A3 Add water to specified levels
A4 Call CleverSpa
A1 Clean/replace filter cartridge
A2 Loosen the Filter slightly
A3 Call CleverSpa
A4 Ask a professional electrician to check
household electrical supply
is functioning correctly
A1 Use repair patch provided
A1 Increase filtration time
A2 Clean/replace filter cartridge
A3 Refer to chemical
manufacturer's instructions
A1 Unplug from mains and wait 30 minutes.
®
Temperature will start to reduce
and return to normal
A2 Clean the inlet
A3 Call CleverSpa
SOLUTION
Check filter and change if necessary.
Once done, press filter again. FC code
will disappear, and warning tone will stop.
Water temperature will be displayed, all
functions will return to normal.
Unplug from mains and wait. Temperature
should start to reduce and return to normal
range. If HL remains after an extended
period of time, contact CleverSpa
Aftersales on
or visit: clevercompany.com.
Contact CleverSpa
+44 (0) 151 318 6163
clevercompany.com.
13
Aftersales if does not reset
®
Aftersales if does not reset
®
Aftersales if it does not reset
®
Aftersales if does not reset
®
®
+44 (0) 151 318 6163
Aftersales on
®
or visit: