Table of Contents
Advertisement
Troubleshooting
The start of the appliance does not work or it stops during operation. First
try to find a solution to the problem, If not, contact the service centre.
Problem
Washer does not
start
Door cannot be
opened
Water leakage
Water overflow from
bottom of
machine
No light in indicator
or display
Detergent
residue in drawer
Washing
effectiveness
reduced
Abnormal noise
High levels of
vibration
Possible Cause
Machine's safety protection
design is working
Check all pipe connections are
tight: - inlet pipe / outlet hose
Drain pipe is blocked
Inlet pipe is not connected
firmly
Outlet hose has water leakage
Power is disconnected
Problem with power-
connector board
Washing powder has
dampened and formed hard
lumps
Clothes are too dirty
Insufficient detergent used
www.haden.com
Solution
Check that the door is closed tightly
Check that the mains plug is fully
inserted
Check that the tap is turned on
Check the water inlet pipe is not
twisted.
Check the 'Start/Pause' button has
been pressed.
Check the 'On/Off' button has been
pressed
Disconnect the power, restart the
product
Check and fasten water pipes
Clean up outlet hose
Re-fasten inlet pipe
Replace drain hose
Check the power socket is OK
Check that the mains plug is fully
inserted
If problem persists, please
telephone the helpline for service
Wipe the detergent drawer clean
Use liquid detergent or special
detergent to clean the drum
Select an appropriate procedure.
Add an appropriate amount of
detergent
according to the instructions on the
detergent pack
Check that transport bolts have been
removed
Check that cabinet has been
installed on a solid, level floor.
Check inside the drum for metal
articles such as hairpins
Check that legs of washing machine
are level
27
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the HWI1480 and is the answer not in the manual?
Questions and answers
Our washer dryer isn’t spinning, I’ve cleaned the drain filter and it turns on but isn’t spinning
The Haden HWI1480 washer may not be spinning after cleaning the drain filter due to the following reasons:
1. Door Not Closed Properly – Ensure the door is tightly shut, as the machine’s safety features prevent operation if the door is not secured.
2. Power Issue – Check that the mains plug is fully inserted and the 'On/Off' button has been pressed.
3. Water Drainage Problem – If water remains inside, check that the drain hose is not blocked and restart the machine after closing the door.
4. Transport Bolts Not Removed – If recently installed or moved, verify that transport bolts have been removed to allow proper drum movement.
5. Unbalanced Load – An unbalanced load can prevent spinning. Try redistributing the clothes inside the drum.
If the issue persists, contacting the service center is recommended.
This answer is automatically generated