C A R E & M A I N T E N A N C E
Cleaning the Air Purifier
•
Unplug before cleaning.
•
Wipe the outside of the air purifier with a soft, dry cloth.
If necessary, wipe the housing with a damp cloth, then
immediately dry.
•
Do not clean with abrasive chemicals or flammable
cleaning agents.
Check Filter Indicator
The Check Filter Indicator
to check the filters. Depending on how much you use the
air purifier, the indicator should turn on within 6–8 months.
You may not need to change your filters yet, but you should
check them when the indicator light turns on.
Resetting the Check Filter Indicator
Reset the Check Filter Indicator when:
•
lights up.
1.
Replace the filters (see page 11).
2.
While the air purifier is plugged in and turned on,
press and hold
purifier beeps.
3.
The light will turn off once it is successfully reset.
•
The filters were changed before
1.
While the air purifier is plugged in and turned on,
press and hold
purifier beeps. This will turn the indicator light on.
2.
Press and hold
purifier beeps.
3.
The light will turn off once it is successfully reset.
10
will light up as a reminder
for 3 seconds until the air
lit up.
for 3 seconds until the air
again for 3 seconds until the air
Cleaning the Filters
A.
The Pre-Filter should be cleaned once a month to
increase efficiency and extend the life of your filters.
Clean the Pre-Filter using a brush to remove hair, dust,
and large particles. Optionally, rinse the Pre-Filter in
clean water.
Note: Always make sure the Pre-Filter is completely dry before
using, because dampness or moisture will damage the True HEPA
Filter.
B.
Do not clean the True HEPA Combination Filter. Fine
dust or bacteria may be released back into the air if
cleaning is attempted, and the filter will be permanently
damaged. Only clean the Pre-Filter.
1
A
1
B
1
C
Need help?
Do you have a question about the LV-H132 and is the answer not in the manual?
Questions and answers