Page 1
Additional faucet for ECAIA ionizer S Additional operating instructions to be used in combination with User manual for the ECAIA ionizer S Distributed worldwide by: SANUSLIFE INTERNATIONAL GmbH Luigi Negrelli 13/C, 39100 Bolzano (I) Phone: +39 0471 979998 www.sanuslife.com - info@sanuslife.com...
ECAIA ionizer S faucet - Display Compare table D (p. 2). Control cable – transmits signal to the ECAIA ionizer S+ Quick release fastener 5/16" – connection for alkaline water outlet Quick release fastener 1/4" – connection for acidic water outlet Display (ECAIA ionizer S faucet) Power button –...
Installation of ECAIA ionizer S+ and ECAIA ionizer S faucet Permanent connection to the angle valve (ECAIA ionizer S+; appliance in below counter position) Compare table E (page 3). The ECAIA ionizer S+ can be permanently connected to the angle valve under the sink, as described under point “1.4 - Permanent connection to the angle valve (appli- ance in above-counter position)”.
quick-release fastener opening of the water inlet (B-11) on the bottom of the ECAIA ionizer S. Finally, fix the 5 1/4” safety pins (C-6) in place. Afterwards, connect the cable of the solenoid valve (C-12) to the cable plug-in connector on the bottom of the ECAIA ionizer S. 4.
Page 8
3. Choose a location next to the sink for the 2-way fitting (C-1) so that it can be operat- ed professionally without interfering with the work around the sink. The location you choose should be approx. 4 cm (1.5") from the edge of the sink and approx. 30 cm (11"-12") from the faucet.
5/16" - 1/4" 1/4" - 1/4" 1/4" The ECAIA ionizer S can be placed in a lower cabinet or mounted to the wall. To do this, please follow the instructions under point “1.6 - ECAIA ionizer S Wall Mounting” in the complete user manual (long version) for the ECAIA ionizer S.
Page 10
3. Press and hold the “acidic level 1” (B-25) button on the ECAIA ionizer S until “F-1” is displayed. 4. Press and hold on the ECAIA ionizer S the button combination “alkaline level 5” (B-24) and “PURIFY” (B-26) at the same time until the display (B-2) switches off. This saves the setting.
Reprogramming the ECAIA ionizer S+ control to ECAIA ionizer S If you wish to use the ECAIA ionizer S+ again without the ECAIA ionizer S faucet, you can reprogram the ECAIA ionizer S controls as described below: 1. On the ECAIA ionizer S faucet, press and hold the “Power (D-D1)” and “Alkaline lev- els (ALK) (D-D2)”...
6. Plug the power cable of the ECAIA ionizer S+ into the socket. You can now use the ECAIA ionizer S+ again using the control panel (B-1) on the ECAIA ionizer S+. Operation of ECAIA ionizer S faucet The device can be switched on and off using the power button (D-D1). The button “ALK”...
Page 14
ACID Filter ② ① Additional faucet for ECAIA ionizer S Distributed worldwide by: SANUSLIFE INTERNATIONAL GmbH Luigi Negrelli 13/C, 39100 Bolzano (I) Phone: +39 0471 979998 www.sanuslife.com - info@sanuslife.com...
Need help?
Do you have a question about the ECAIA S and is the answer not in the manual?
Questions and answers