Spark Plug; Good Fuse; Blown Fuse - TVS Stryker 125 Manual

MAINTENANCE
1. Open the cover frame L (refer page no. 21) and pull out
the fuse case from its location.
2. The fuse cases contains two 10A fuses. Open the fuse
case cover and pull out the blown fuse.
3. Replace the fuse with a new (extra fuse is provided in a
pouch in the wiring harness itself). Close the fuse case
cover.
4. Turn the ignition 'ON' and check for proper functioning
of electrical systems. Incase the fuse fails again, consult
nearest TVS Motor Company Authorised Distributor or
Dealer / Authorised Service Centers.

Good Fuse

CAUTION
Do not use vehicle by shorting the wires without a fuse. This may
result in overheating of electrical / wiring and may result in fire. Do
not use fuse of higher amperage than specified for the safety
of electrical system.

SPARK PLUG

1. Clean the dust and mud around the spark plug
mounting to avoid falling inside the cylinder.
2. Pullout the suppressor cap from spark plug. Using spark
plug spanner, remove the spark plug.
A spark plug with heavy carbon deposits will not produce
strong sparks. Hence, only if necessary, remove the carbon
deposits from the spark plug with a small wire brush or
spark plug cleaning tool.

Blown Fuse

33