Grange PORTICO PERGOLA Assembly Instructions page 2

Portico [A5 4page instructions] 19/9/17
Thank you for choosing this garden structure from Grange. In order to gain the
most benefit from it please read the following instructions carefully.
TOOLS REQUIRED (Not Supplied)
POWER SCREWDRIVER
TAPE MEASURE
STEPLADDER
SPIRIT LEVEL
PARTS LIST
A
POSTS 4
B
SQUARE TRELLIS 2
C
RAFTERS 2
D
RAFTERS 4
HARDWARE PACK
x
SCREW 5 x 80 32
BEFORE YOU START
•
Please ensure that you check all the component parts for quantity and quality before you commence building the
product. Report any missing parts immediately. The manufacturer will not accept any responsibility for damaged items
once any part of the product has been fitted or altered in any way.
•
Timber is a natural material and will react to varying levels of moisture content - ie. will swell or shrink. All of the Timber
components are pressure treated green. However, should extra protection be required, they should be treated using a
wood preservative treatment, following the manufacturers instructions.
HEALTH AND SAFETY
Do NOT overstretch when working from the step ladder.
In order to reduce the risk of suffocation please keep all plastic bags and small parts away from children.
•
When you are ready to start, make sure you have the right tools to hand, plenty of space and a
clean, dry area for assembly.
It is advisable for two people erect the structure.
PREPARATION
Make sure the area where the Portico is to be positioned is clear and ready for building the structure.
10:01 Page 2
B
C
D
A
x
ASSEMBLY INSTRUCTIONS
SITE PREPARATION
Mark out the area where the
PORTICO
structure is to be sited using
'FOOTPRINT'
the footprint shown right.
Measurements
Excavate a hole for each post
indicated to
to a depth of 30cm (see
centres of posts.
fig.1) This will give your
structure adequate stability.
Fig.1
ASSEMBLY
STEP 1
A
Take two of the Posts (A) and
one piece of the Trellis (B)
and fix the trellis to each of
the posts using screws (x) as
shown in Fig.2.
STEP 2
Repeat for the other
two posts and trellis.
STEP 3
Determine the width
SITE PREPARATION
required between the two
assemblies and place one of
the rafters (C) into the top of
STEP 3-4
one of the posts. Set the
distance between the post
and the end of the rafter and
fix in place using screws (x)
C
as shown in Fig.3.
STEP 4
Fix the other Rafter (C) into
the post in the same
Fig.3
assembly in the same way -
see Fig.3.
B
STEP 5
A
Lift the two rafters and
locate into the top of the
other post and trellis
assembly. Set the rafters at
the same distance from the
end and screw in place using
screws (x).
STEP 6
Space the four Rafters (D)
across the assembly equally
x
and fix in place using screws
D
(x).
A
112.5cm
B
STEP 1 x
Fig.2
x
x
A
x
C
A
STEP 6
= = =
D
C
=
C
A
=