Wolverine Brass Essence 85940 Installation Instructions

INSTALLATION INSTRUCTIONS
Essence
Kitchen Faucet
Single Control with Pull Out Spray
85940
Polished Chrome
85941
Brushed Nickel
SPECIFICATIONS
• 35mm Ceramic Disc with Hot
Temperature Limit Adjustment
Ring.
• Brass Body with Copper Supplies
• Brass Supply Connection
Adapters with 1/2" IPS Threads.
• Polished Chrome Plated Metal
Handle.
• Single Control Lever Handle.
• Requires less than 5 lb force to
operate Handle.
• Temperature Adjustment 90° Full
Cold to Full Hot.
• 1.8 GPM (6.8 L/min) Aerator.
NEED HELP?
For additional assistance or service please contact:
1 Assemble Deck Plate to Faucet
2 Assemble Putty Plate to Faucet
3 Position Faucet on sink
4 From underside of sink, assemble Shank
Mount Washer and Shank Mount Nut, then
assemble Nuts to the Deck Plate Studs
5 Assemble Braided Spray Hose to the Hose
Quick Connect Fitting.
CAUTION: Make sure the Braided Spray Hose is
properly engaged and secure into the Hose Quick
Connect Fitting.
6 Assemble Hose Weight to the Braided Spray Hose.
7 Assemble Water Supply Lines to Faucet.
CAUTION: Use Wrench or Pliers to hold Faucet Inlet
Adapters when tightening Water Supply Line Nuts
to prevent twisting Copper Tubing or damaging
Solder Joints.
8 Remove Spray Wand from Faucet and flush
water through Faucet to remove any debris
within the system.
9 Assemble Spray Wand to Faucet and run
water through Faucet while inspecting all
connections for possible leaks.
SINGLE HOLE INSTALLATION
1 Assemble Single Hole Mount Flange to Faucet
2 Follow steps 4 through 9 from "3 HOLE INSTALLATION".
800-944-9292
3 HOLE INSTALLATION
www.wolverinebrass.com
92-85940-03