Motorola XTS1500 Manual

1. Turn-On the Radio
• Turn the VOLUME control clockwise.
• The bi-color LED will flash red & green while befornming
a self test. Wait 10 seconds to allow the radio to register
with the system before talking.
2. Select a Zone
• Press Side Button 1 to change zones.
3. Select a Talkgroup
• Turn the TALKGROUP SELECTOR knob on the top of
the radio to the desired position.
4. Transmit a Message
• Listen to be sure no one is using the Talkgroup.
• Press and hold the PUSH-TO-TALK button on the side
of the radio.
• Wait for the TALK PERMIT tones (beep-beep-beep)
before speaking.
• Release the PUSH-TO-TALK button to listen.
ZONE
Steele County Emergency Management
Motorola XTS1500 Portable Radios
WARN 01 thru WARN 12
Steele County Emergency Management
Motorola XTS-1500 Zone Map
WARN01 thru WARN12
SEM
1 SCEM OP1 SCEM OP1
2 SCEM OP2 SCEM OP2
3 SCEM CMD SCEM CMD
4 STEELE 1 STEELE 1
5 STEELE 2 STEELE 2
6 STEELE 3 STEELE 3
7 SEM TAC OWFD OP1
8 PS COM OWFD OP2
9 COMMON OWFD OP3
10 SL ROAM MEFD OP1
11 DYN RGP ELFD OP1
12 SOA-1 BPFD OP1
13 SOA-2 OPU OPS1
14 SOA-3 F-SOA-1
15 SOA-4 F-SOA-2
16 SL-911 SCFDMAIN
If You Hear a "Chirping" Sound
• The battery is running low.
• As the battery grows weaker, the CHIRPING
SOUND will appear more frequently until the
battery finally runs out.
• It takes about 3 hours to recharge a battery.
If you hear a "BONK"
• The Talkgroup or System is busy.
• Release the PUSH-TO-TALK switch.
• When the Talkgroup or System is available, you will
hear the TALK PERMIT tones.
• Press and hold the PUSH-TO-TALK button to
transmit.
FIR SE
SE-CALL SOA-1
SE-2 SOA-2
SE-3 SOA-3
SE-4 SOA-4
SE-5 F-SOA-1
SE-6 F-SOA-2
SE-7 8CALL90D
SE-8 8TAC91-D
SE-9 8TAC92-D
SE-10 8TAC93-D
SE-11 8TAC94-D
SE-12 8CALL90R
SE-13 8TAC91-R SCEM CMD
SCEM OP1 8TAC92-R
SCEM OP2 8TAC93-R
SE-CALL 8TAC94-R
8-C MN BLANK
S-TAC-1
S-TAC-2
S-TAC-3
S-TAC-4
S-TAC-5
S-TAC-6
S-TAC-7
S-TAC-8
S-TAC-9
S-TAC-10
S-TAC-11
S-TAC-12
SCEM OP1
SCEM OP2
SL-911
23-Mar-2015