Cambridge Audio AXR100D Manual
  1. Manuals
  2. Brands
  3. Cambridge Audio Manuals
  4. Stereo Receiver
  5. AXR100D
  6. Manual

Cambridge Audio AXR100D Manual

Hide thumbs Also See for AXR100D:
Table of Contents

Advertisement

Quick Links

AXR100D
STEREO RECEIVER

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AXR100D and is the answer not in the manual?

Questions and answers

Related Manuals for Cambridge Audio AXR100D

Summary of Contents for Cambridge Audio AXR100D

  • Page 1 AXR100D STEREO RECEIVER...

  • Page 2: Table Of Contents

    RE AR PANEL CONNECTIONS Cambridge Audio’s policy is one of continuous improvement, therefore design and specifications are subject to change without prior notice. FRONT PANEL CONTROL S This document contains proprietary information protected by copyright.

  • Page 3: Important Safety Instructions

    11. Only use attachments/accessories specified by the manufacturer. and installed according to this instruction manual. For continued compliance only Cambridge Audio accessories should be used with this product and servicing must be 12. Use with only the cart, stand, tripod, bracket, or table specified by the referred to qualified service personnel.
  • Page 4 OVERLOADING Do not overload wall outlets or extension cord as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation, and broken plugs are dangerous. They may result in a shock or fire hazard.

  • Page 5: Rear Panel Connections

    Moving Magnet (MM) tPlease consult your dealer for details. The ‘ground’ outputs together. Please ensure that the loudspeaker terminals have been tightened terminals on both the record player and the AXR100D should be connected (where adequately to provide a good electrical connection. It is possible for the sound quality possible) with a ground wire for lowest noise/hum pickup.

  • Page 6: Front Panel Controls

    Front panel controls R100D DAB / FM A1 / D1 A2 / D2 A3 / D3 / PHONO SPEAKER A / B MENU VOLUME MODE / STORE 1 / 6 2 / 7 3 / 8 4 / 9 5 / 10 AUX IN POWER BUTTON DISPLAY...

  • Page 7: Remote Control

    AXR100D Remote control The AXR100D is supplied with a remote control that operates this unit and its built- in tuner. In addition, the buttons with Blue coloured icons can operate a matching AX CD player. Always use Alkaline batteries. POWER BUTTON Switches the unit between Standby mode and On.

  • Page 8: Connections

    Connections LOUDSPEAKERS Check the impedance of your speakers. You can use types with an impedance of 8 Ohms. The red coloured speaker terminals are positive (+) and the black speaker terminals are negative (-). Make sure correct polarity is maintained at each speaker connector or the sound can become weak and “phasey”...
  • Page 9 AXR100D SPEAKER B CONNECTIONS The Speaker B connections on the back of the amplifier allow for a second set of Note: When using two pairs of speakers, use speakers with a nominal impedance speakers to be used (i.e. speakers located in another room).

  • Page 10: Aerials

    Auto Scan To add another Bluetooth device, Press and hold the /Phono button to disconnect the current connection and repeat step 2. AXR100D will store up to 8 paired devices in memory. MODE / STORE ADJUSTING THE VOLUME Use either the Volume Up/Down buttons on the remote control, or the Volume control on the front of your unit system to change the volume level.

  • Page 11: Setting

    It is very important that once the Firmware upgrade up to 40 presets for each band (i.e. 40 presets for the DAB band plus 40 presets for has started you do not switch off the power to the AXR100D + until the operation is the FM band).

  • Page 12: Technical Specifications

    Technical specifications Power output 100 watts (into 8Ω) THD (unweighted) <0.01% @ 1kHz, 80% of rated power <0.15% 20Hz - 20kHz, 80% of rated power Frequency response (-1dB) 5Hz - 50kHz S/N ratio (ref 1W) >82dB (unweighted) Input impedances 47k ohms Power Amp damping factor >50 Standby power consumption...

  • Page 13: Troubleshooting

    Use of two pairs of speakers which are less than 8 Ohms can cause overloading and is not recommended. If you have questions about your Cambridge Audio product visit https://support.cambridgeaudio.com where you will find FAQs and guides to assist you..
  • Page 14 Gallery Court, Hankey Place London SE1 4BB United Kingdom Cambridge Audio is a brand of Audio Partnership Plc. Registered in England No. 2953313 AP37514/A...

Table of Contents