Advertisement
Quick Links
Strand - 3 Door Centre Mirror Wardrobe
Assembly Instructions
Dimensions
Width - 122.2cm
Depth - 53.6cm
Height - 196cm
Important
– Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Homebase = 0345 0778888
- Please keep for future reference
177/7772
267/5457
149/3719
BK03400 - Issue 1 - 11/06/2014
Advertisement
Related Manuals for Homebase 177/7772
Summary of Contents for Homebase 177/7772
- Page 1 Depth - 53.6cm Height - 196cm Important – Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the Customer Helpline: Homebase = 0345 0778888 BK03400 - Issue 1 - 11/06/2014...
- Page 2 Safety and Care Advice Important – Please read these instructions fully before starting assembly • Check you have all the • Assemble on a soft level • We do not components and tools listed on surface to avoid damaging the recommend the pages 2 and 3.
- Page 3 If you have damaged or missing components, call the Components - Panels Homebase = 0345 0778888 Customer Helpline: Please check you have all the panels listed below Double wardrobe Single wardrobe (191 x 82.2 x 53.6cm) (191 x 42.2 x 53.6cm) Cornice (122.2 x 5cm)
- Page 4 Components - Fittings Please check you have all the fi ttings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fi ttings may be supplied than are required. 15mm Screw x 1 15mm Washer x 2 Wall strap x 1 13mm Cornice screw x 2...
- Page 5 Assembly Instructions Step 1 Position and connect the units Before connecting the units you will fi rst need to remove all doors. Loosen but do not remove bolt B in the centre of the hinge back plates which are attached to the wardrobe side panel.
- Page 6 Assembly Instructions Step 2 Re-fi tting the doors Starting from the top, slide the keyhole shaped groove in the hinge over bolt B on the hinge plate. Once located tighten bolt B and move on to the next hinge. Step 3 Remove and replace handles The bar handles are...
- Page 7 Assembly Instructions Step 3 - continued Replace the bar handle on the front of the unit. Fix in position by screwing the 22mm handle screw into each bar handle from inside the unit using a Philips screwdriver. Bar handle Note: Only use the 20mm handle screw that the handles were pre- fi...
- Page 8 Assembly Instructions Step 4 - continued When fi xed in place fully secure by screwing the13mm cornice screws through the Angle bracket angle brackets in to the wardrobe using a philips screwdriver. Note: There are not any pre-drilled holes in the top of the robe for this.
- Page 9 ‘B’, this allows the hinge arm to slide back and forth. Adjust as required then re-tighten screw ‘B’. Assembly is complete. Customer Helpline: If you need help or have damaged or missing parts, call the Homebase = 0345 0778888...
Need help?
Do you have a question about the 177/7772 and is the answer not in the manual?
Questions and answers