Sealey SG16.V4 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to the
Wear eye
instruction
protection
manual
1. SAFETY
WARNING! Disconnect the gun from the air supply before changing accessories, servicing or performing any maintenance.
‰
Maintain the gun in good condition. Replace or repair damaged parts. Use recommended parts only. Non-authorised parts may be
9
dangerous and will invalidate the warranty.
Keep the gun clean and rinse out the nozzle/injection probe and pipes with thinners after use.
9
WARNING! If the gun components become blocked there is a danger of excessive pressure building up in the unit, causing the
‰
canister to burst.
Wear the appropriate approved personal protective equipment when using the gun. A full range of personal protective equipment is
9
available from your Sealey dealer.
Locate the gun in a suitable, well ventilated area, keep area clean, tidy and free from unrelated materials and ensure there is
9
adequate lighting.
Ensure that a vehicle that has been jacked up is adequately supported with axle stands.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
9
Keep children and unauthorised persons away from the working area.
9
Avoid unintentional operation.
9
Ensure the coating/wax manufacturer's instructions are carefully adhered too.
9
DO NOT hold the gun or attachments close to your face (especially eyes, ears, etc.) and DO NOT point the gun or air hose at other
8
persons or animals.
DO NOT carry by the air hose, or pull the hose or the gun from the air supply.
8
DO NOT use the gun for any purpose other than for which it is designed and do not fill with any other fluid.
8
DO NOT operate the gun if damaged.
8
When not in use, disconnect from the air supply and store in a safe, dry, childproof area.
9
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into
this product, but must be applied by the operator.
2. INTRODUCTION
Features air control valve, making it suitable for various applications. Supplied with canister and wax injection probe.
3. SPECIFICATION
Model no: ................................................................SG16.V4
Air pressure: ............................................................60-115psi
Air consumption: ..................................................... 10-13cfm
Air inlet size:..............................................................1/4"BSP
4. CONTENTS
Item No Description
1 Gun
2 Canister
3 Nozzle
4 Canister Cap
5 Injection Probe
6 Hose Fitting
7 Air control valve
© Jack Sealey Limited
INSTRUCTIONS FOR
UNDERBODY COATING SPRAY GUN
AIR OPERATED DELUXE MODEL
MODEL NO:
Wear a mask
Qty
1
1
1
1
1
1
1
Original Language Version
SG16.V4
SG16.V4| Issue 1 15/09/16