Thicknessing - Mac allister MPTP1500B MAC Original Instructions Manual

MPTP1500B MAC
GB
WARNING!!!
The part of the cutter block not used must by covered by the
guard. Working position is in front of the machine at the side of
the infeed table. Put the fingers of both hands on top of the work
piece. Do not hold the work piece edges.
The work pieces to be planed must lie firmly on the table so they
can be guided safely. For short work pieces use a feed stick.

Thicknessing

• Following the scale and using the handle O on the spindle, set the thick-
nessing table to the desired height. 1 rotation = 3 mm.
• Narrow wood is introduced in the centre.
When thicknessing, the table must be treated with oil at regular intervals.
After a long period of use, or when planing humid wood, it can happen that
the work piece is not further pulled in.
WARNING!!!
In case of a defect, switch off the machine at once. Do not
remove any chips or splinters from the tables while the machine
is running. Work pieces below 250 mm may not be planed.
32
Operation