Cleaning Up And Creating A Backup - HP 9000 Superdome Installation Manual

Step 7. Run the jet utility by entering the following:
<hostname>% jet
NOTE
Step 8. Change to the complex directory be entering:
<hostname>% cd cplx_[gsp_hostname]
Verify that jet ran correctly
Running JUST
Step 1. On the SMS, enter the following to run JUST:
<hostname>% just -s [GSP hostname]
Step 2. Verify the scan tests passed by entering the following at the JUST prompt:
just> idv or d
If the system is an SD64 (two cabinets), check the flex cables by entering the following:
just> cable
Step 3. Exit JUST by entering q at the just prompt.
Step 4. Power cycle the Superdome system.
Verifying Firmware
Validate the firmware revision by using the sysrev command on the MP.
CM> sysrev

Cleaning Up and Creating a Backup

Step 1. Create a backup tape on the DAT drive by entering the following:
# /opt/ignite/bin/make_tape_recovery -A
Step 2. Check all MP error logs:
ctrl+b, sl
Appendix A
If the system does not return in 5-10 seconds, there could be a problem.
hp Server rx2600 Support Management Station
Configuring the SMS
147