Sealey TD1202S Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. saFety
When selecting web lashings (tie downs) consideration must be
9
given to the required lashing capacity, taking into account the
mode of use and the nature of the load to be secured.
tie downs must be strong enough and of the correct length for
9
the mode of use.
take care that the load is stable when the tie down is released.
9
Avoid exposure of the tie down to chemicals.
9
do not use if tie down is damaged. A visual inspection before
8
use is recommended.
Avoid sharp edges. Protect tie downs by using sleeves or
9
corner protectors.
do not overload.
do not use if knotted.
8
2. introduction
Manufactured from polyester webbing with stitched reinforcement around hooks and all fixing points. Suitable for securing weighty
loads and tarpaulins onto trailers. ratchet mechanically tensions the webbing using a simple drum and ratchet mechanism providing
superior load restraint. sliding feature allows mechanism to be located at any point along run of webbing, resulting in reduced load
damage and ease of operation. Hook and loop retainers tidy away excess webbing for improved safety and reduced wear. supplied in
plastic display case.
3. speciFication
model no: ............................................................. td1202sr
Quantity:............................................................................... 2
maximum tension: ........................................................ 600kg
load test: ................................................................... 1200kg
Webbing width: ............................................................. 32mm
Webbing length: ..............................................................3mtr
Hook: ...........................................................................s-type
4. operation
fig.1
4.1. tightening
4.1.1. Open ratchet to unlocked position, fig.1.
4.1.2. Place switching latch in sliding position, fig.2.
4.1.3. Be sure the centre shaft of the ratchet is parallel with the webbing, fig.3. When the ratchet is open the centre shaft can be turned
manually, fig.4.
4.1.4. Slide the ratchet along the webbing to the desired operating position, fig.1.
4.1.5. Place the switching latch in the locked position, fig.2.
4.1.6. Attach hook to anchor ring, fig.5.
4.1.7. make sure webbing is not twisted.
© Jack sealey limited
instructions for
slide ratchet tie down 32mm x 3mtr polyester
webbing with s hooks 1200kg load test
td1202sr
model no:
fig.2
Original Language Version
fig.3
td1202sr | issue:1 13/10/17
fig.4 fig.5