Advertisement
media:scape
®
mini and mobile -
®
Puck Replacement & Power Switch
1/16" ALLEN WRENCH
®
®
media:scape
mini
media:scape
mobile
STRONG MAGNET
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©
2011 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Page 1 of 7
939501567 Rev A
Printed in U.S.A.
Advertisement
Table of Contents
Related Manuals for Steelcase media:scape mini
Summary of Contents for Steelcase media:scape mini
- Page 1 STRONG MAGNET If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S.
- Page 2 ® Note: Pages 2 through 6 describe a media:scape mini unit. Refer to page 7 for the differences if your unit is a media:scape mobile. Remove the television from the unit (depress dislodgement tabs on mounting brackets). Remove the shroud from the unit. (depress dislodgement tabs on unit).
- Page 3 ® Remove the puck connectors and/or the power on connection from the switcher. (use small flat head screwdriver). (4) PUCK CONNECTORS (1) POWER CONNECTOR Page 3 of 7 939501567 Rev A...
- Page 4 ® Rotate the unit so that you have access to the bottom (two persons required). Remove the plastic base cover with a Phillips screwdriver. Remove the media:well from the unit by removing (4) screws (Phillips screwdriver). Remove (4) screws that hold Remove (6) screws the media:well onto the steel bridge and plastic base.
- Page 5 ® a) Remove (6) screws from the media:well, then b) remove the bezel. NOTE: If you are replacing the power-on button, proceed to step 8. If not, go right to step 11. Remove the power-on button by Use a 1/16” removing (2) screws from the bezel with allen wrench a 1/16”...
- Page 6 ® Remove (2) screws Remove electrical enclosure by removing each side. (4) screws. Remove puck that is intended for replacement. Route the replacement puck cord. ELECTRICAL ENCLOSURE When assembling the new puck, the grommet should be 42” from the end of the cord. Assemble electrical enclosure with the 4 screws that were removed in step 12.
- Page 7 PLATES Note: This page shows the differences MAGNET between a media:scape mobile and a media:scape mini unit. Follow the procedures described on pages 2 through 6 except the following: Remove (2) screws A) Steps 4 and 5 not needed. Remove flocking plate with a strong magnet.
Need help?
Do you have a question about the media:scape mini and is the answer not in the manual?
Questions and answers