14” compact downcut concrete and asphalt saw (18 pages)
Summary of Contents for Edco TMS-10
Page 1
E-TMS10-PL-0113 REVISED STARTING SERIAL # 130110096 PARTS LIST MANUAL MODEL TMS-10 SHOWN WITH OPTIONAL FOLDING STAND PART N0. 24150 10” E LECTRIC SKU # MODEL # POWER OPTION 24200 TMS10-1.5L LEESON ELECTRIC MOTOR 1.5HP 60Hz 1-PHASE 24200-50 TMS10-1.5L/50 LEESON ELECTRIC MOTOR 1.5HP 50Hz 1-PHASE...
E-TMS10-PL-0113 READ AND UNDERSTAND THE OPERATORS INSTRUCTION MANUAL THOROUGHLY BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT. Death or serious injury could occur if this machine is used improperly. SAFETY • Do not disconnect power by pulling cord. To disconnect, grasp SAFETY MESSAGES the plug, not the cord.
HOW TO ORDER REPLACEMENT PARTS FILL IN INFORMATION BELOW To insure product safety and reliability, always use genuine EDCO replacement parts when making Date of Purchase ______________________________ repairs to the equipment. When calling for parts, specify the MODEL and ...
E-TMS10-PL-0113 DECAL SHEET CHECK OIL DAILY W A R N I N G exceeds 85dBA THERE IS NO OIL IN THIS MACHINE edcoinc.com 1-800-638-3326 edcoinc.com 1-800-638-3326 CALIFORNIA PROPOSITION 65 WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
E-TMS10-PL-0113 WIRING DIAGRAM FOR 50 HERTZ MOTOR LEESON CAT. NO. 103176 1.5HP 50Hz 1-PHASE REPLACEMENT PARTS PART # DESCRIPTION 16139 SWITCH, TOGGLE DPST (ON/OFF) 16545 RESET BUTTON, LEESON 300067.02 CEJ51CA 16174 CAPACITOR, RUN, LEESON 003014.02, 50MFD 240V 16181 CAPACITOR, START, LEESON 003024.01, 374 MFD 115V 100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA Printed in USA Phone (301) 663-1600 •...
Page 16
*Seller reserves the right to hold shipments against past due accounts. EDCO will, at its option, repair or replace, at the EDCO factory or at a point designated by EDCO, any part which shall appear to the satisfaction of EDCO inspection to have been *Seller reserves the right to alter payment terms.
Need help?
Do you have a question about the TMS-10 and is the answer not in the manual?
Questions and answers