Reboot/Default The Inception Controller - Inner Range Inception Installation Manual

Inner Range Inception Security Controller

Reboot/Default the Inception Controller.

An Inception controller can be reset and/or defaulted by
two methods:
1) By pressing the reset button on the unit with a
paper clip or pin as described below.
Reset button action
Single short press.
Press and hold for 5
seconds.
Press 5 times in less
than 5 seconds.
2) The Inception controller can be reset to the Factory Default settings from the browser. Use
the "Reset to Factory Default" button in the Backup/Restore options under "System".
See screen image below.
Note: If reset using this option, Review and System Log will not be removed. To remove
these items use the Reset button option instead.
© 2016 - 2020. Inner Range Pty Ltd.
Operation
Reboot the Controller.
No settings or programming are changed.
Factory default. All settings and
programming are restored to the factory
default including installer codes and
logins.
Installer reset only. The installer code,
web profile and permissions are reset or
re-created.
21
Installation Manual. Rev. 4.0
Reset
button
Feedback
Single beep.
Single beep at start
and higher pitched
beep at end of 5s
button press.
5 beep sequence with
last beep higher pitch.
Factory Default option
www.innerrange.com