Vahle KBHF Troubleshooting Manual

KBHF Trouble Shooting Guide

**IMPORTANT: Always disconnect and lock out system from mains/power supply

before performing any inspection or installation work **

Layout Guide Lines:

 First and Last Hanger – Must be placed at least 250 mm from end of system with

a max distance of 500mm allowed.

 Fix point Hanger – 1x per system, centered approximately. All other hangers

must be sliding

 Distance from joints – At least 250mm, max distance of 500mm allowed.

Incorrect Installation

* System Length under 70m, no curves *



See installation instruction for step by step

directions.



Joint Cap – Ensure joint caps are installed

correctly and engaged at top, side and bottom. (see

photo)



Placement – ensure hangers are placed in

accordance with the minimum distance of 250mm and

max distance of 500mm.

Table of Contents

Do you have a question about the KBHF and is the answer not in the manual?

Page 1 KBHF Trouble Shooting Guide * System Length under 70m, no curves * **IMPORTANT: Always disconnect and lock out system from mains/power supply before performing any inspection or installation work ** Layout Guide Lines: Hanger Placement:  First and Last Hanger – Must be placed at least 250 mm from end of system with a max distance of 500mm allowed.
Page 2 Conductor Bar Installation:  Visually inspect system to ensure no horizontal or vertical deviation. Conductor bar should be installed precisely aligned to the runway. (See photo) Incorrect Installation Inspection:  Visually inspect each joint to ensure proper connection and engagement of cap. Joint should be smooth and without any burr to avoid damage to collector brush.