Table of Contents
Advertisement
CHAPTER 7: OPERATION
The current configuration is saved in the permanent memory of the matrix and the matrix will be shut
down.
After shutting down, a notification to power off the matrix appears.
FIGURE 7-11.5.3 MANAGEMENT SOFTWARE DIALOG LOG SWITCH OFF MATRIX
7.11.6 RESETTING THE MATRIX TO THE FACTORY SETTINGS
If you perform a (factory) reset, all current settings and all configurations stored in the matrix will be lost.
This also applies to the network parameters (reset to default IP-address) and the admin password.
*If a firmware update has been installed since the delivery, the matrix will be set to the state defined there.
To perform a reset of the matrix, proceed as follows:
1. Select Device > Advanced Service > Factory Reset > Factory Reset in the menu bar.
An access window appears.
2. Enter the username and password of the administrator.
3. Click the Ok button to confirm your entries.
FIGURE 7-11.6.1 MANAGEMENT SOFTWARE DIALOG LOG IN ADMINSTRATOR
NOTICE
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
310
Advertisement
Table of Contents
