Updating Firmware - IRC Ghost Atto Duo Preliminary Operator's Manual

Updating Firmware
JR Module
Connect your PC to the Ghost JR module using a micro-USB cable.
Press the ​ S tart Update​ button to start the procedure.
If for any reason the Ghost Tx display does not turn on, power up the module with the joystick
pressed to force boot load mode.
Receivers
All Ghost receivers are updated using an over-the-air technology during binding.
If a Rx firmware update was necessary, once complete, ​ d on't immediately power down ​ the Rx,
leave it for 10-20 seconds to finalize the update. (LED will flash a few times to indicate update
progress)
ImmersionRC Limited, Kwai Chung, NT, Hong Kong, www.immersionrc.com