Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for REL Strata II
Summary of Contents for REL Strata II
- Page 1 Operating Instructions for the Strata II Sub-Bass System REL Acoustics Ltd North Road, Bridgend Industrial Estate, Bridgend, Mid Glamorgan, CF31 3TP. United Kingdom. Telephone: 01 656 768 777; International: +441 656 768 777 Fax: 01 656 766 093 International: +441 656 766 093...
-
Page 2: Service After Warranty
This Warranty is offered in good faith and is in addition to any statuary rights or existing Warranty that may be available to the end user. Should your STRATA II unit give you a problem, please contact your Dealer who will be able to make whatever arrangements are necessary to correct it. - Page 3 Neutrik Speakon signal interconnect supplied with Strata II and connected to your existing speaker plugs, or connect the Strata II lead to a spare set of speaker terminals. In effect, Strata II is bi-wired from your power amplifier. However, note that there are only three connections to Strata II.
- Page 4 To take advantage of this option simply feed your preamp output to the Strata II and then use one of the pairs of output phonos on Strata II to feed your power amplifier. This can have some advantage concerning the maximum power handling capability, but has the disadvantage of affecting main signal purity.
- Page 5 This helps to ensure better system integration between the two systems (your main speakers and Strata II). This is a very important point and together with the Strata II’s Active Bass Controller (ABC), ensures far superior system integration of the sub-bass with the main system.
- Page 6 CARE OF YOUR STRATA II The high quality finish of Strata II is easily cared for by the occasional wipe over with a damp cloth. Alternatively, a soft bristled brush may be used to sweep off any dust which faIls on the surface.
-
Page 7: Some Do's And Don'ts
SOME DO'S AND DON'TS 1. Always protect the sub-woofer from getting wet. 2. Always ensure that the panel is correctly earthed via the three-core mains cable. It is not sufficient to rely upon the earth being made via the signal ground. 3. - Page 8 ACTIVE BASS CONTROLLER SWITCH versus CROSSOVER FREQUENCY These settings determine the commencement of the upper frequency limit of the sub-woofer. The lowest operating frequency is totally unaffected by these switches. The four steps on the fine control are equal to one on the coarse. SWITCH POSITIONS FREQUENCY COARSE...
-
Page 9: Specification
SPECIFICATION TYPE REFLEX Extended response ENCLOSURE VOLUME 40 litres INPUT CONNECTORS Neutrik Speakon and twin phono sockets BASS CUT OUTPUTS: Cut below 50Hz Cut below 100Hz (Both measured into 10k ohms impedance) GAIN CONTROL RANGE 80dB AMPLIFIER TYPE DC coupled complementary Mos-Fet INPUT IMPEDANCES: HIGH LEVEL... - Page 10 (3) Operating manual. (4) Set of spikes. In the interest of product development, REL Acoustics Limited reserves the right to vary this specification without notice. Please Note This apparatus is designed to Class II specification and is double insulated, therefore it...
- Page 11 - the wire coloured Brown must be connected to the terminal marked with the letter “L" or coloured Red. Revised July 9 1997, Nov 11 1997 This product is CE marked and has been tested to ensure it satisfies all relevant standards for EN 50081-1 using the limits of EN 55022 class B and IEC 801 - 4 wherever relevant.
Need help?
Do you have a question about the Strata II and is the answer not in the manual?
Questions and answers