Advertisement
(7) Match the back cover (114) to arm and tighten the screw on the left of the back cover (114) loosely.
(8) Take out the driving link (115) from the groove of the back cover (114).
(Pull the knuckle to the point in the under.)
(9) Fix the groove in the point of the driving (115) link into the pin between nylon washer and
nylon washer.
(10) Match the screw hole of the bracket (113) and the hole of the driving link (115) and tighten
the bolt (117).
(11) Take out the machine head support on the table.
(12) Tighten all the screws of the back cover (114). and, it is assembly completion.
KNUCKLE
NYLON
WASHER
5.3 Exchange of feed dog, fixed knife, and needle plate.
Exchange parts of the figure below which you have for the one (101, 102, 103) of the accessory.
101
113
102
114
115
GROOVE
- 6 -
117
103
Advertisement
